Coherent links between qubits separated by tens of micrometers are expected to facilitate scalable quantum computing architectures for spin qubits in electrically defined quantum dots. These links create space for classical on-chip control electronics between qubit arrays, which can help to alleviate the so-called wiring bottleneck. A promising method of achieving coherent links between distant spin qubits consists of shuttling the spin through an array of quantum dots. Here, we use a linear array of four tunnel-coupled quantum dots in a 28Si/SiGe heterostructure to create a short quantum link. We move an electron spin through the quantum dot array by adjusting the electrochemical potential for each quantum dot sequentially. By pulsing the gates repeatedly, we shuttle an electron forward and backward through the array up to 250 times, which corresponds to a total distance of approximately 80μm. We make an estimate of the spin-flip probability per hop in these experiments and conclude that this is well below 0.01% per hop.

Semiconductor spin qubits have gained increasing attention as a possible platform to host a fault-tolerant quantum computer. First demonstrations of spin qubit arrays have been shown in a wide variety of semiconductor materials. The highest performance for spin qubit logic has been realized in silicon, but scaling silicon quantum dot arrays in two dimensions has proven to be challenging. By taking advantage of high-quality heterostructures and carefully designed gate patterns, we are able to form a tunnel coupled 2 × 2 quantum dot array in a ²⁸Si/SiGe heterostructure. We are able to load a single electron in all four quantum dots, thus reaching the (1,1,1,1) charge state. Furthermore, we characterize and control the tunnel coupling between all pairs of dots by measuring polarization lines over a wide range of barrier gate voltages. Tunnel couplings can be tuned from about 30 μ eV up to approximately 400 μ eV . These experiments provide insightful information on how to design 2D quantum dot arrays and constitute a first step toward the operation of spin qubits in ²⁸Si/SiGe quantum dots in two dimensions.

As spin-based quantum processors grow in size and complexity, maintaining high fidelities and minimizing crosstalk will be essential for the successful implementation of quantum algorithms and error-correction protocols. In particular, recent experiments have highlighted pernicious transient qubit frequency shifts associated with microwave qubit driving. Work-Arounds for small devices, including prepulsing with an off-resonant microwave burst to bring a device to a steady state, wait times prior to measurement, and qubit-specific calibrations all bode ill for device scalability. Here, we make substantial progress in understanding and overcoming this effect. We report a surprising nonmonotonic relation between mixing chamber temperature and spin Larmor frequency which is consistent with observed frequency shifts induced by microwave and baseband control signals. We find that purposefully operating the device at 200 mK greatly suppresses the adverse heating effect while not compromising qubit coherence or single-qubit fidelity benchmarks. Furthermore, systematic non-Markovian crosstalk is greatly reduced. Our results provide a straightforward means of improving the quality of multispin control while simplifying calibration procedures for future spin-based quantum processors.

Future quantum computers capable of solving relevant problems will require a large number of qubits that can be operated reliably1. However, the requirements of having a large qubit count and operating with high fidelity are typically conflicting. Spins in semiconductor quantum dots show long-term promise2,3 but demonstrations so far use between one and four qubits and typically optimize the fidelity of either single- or two-qubit operations, or initialization and readout4-11. Here, we increase the number of qubits and simultaneously achieve respectable fidelities for universal operation, state preparation and measurement. We design, fabricate and operate a six-qubit processor with a focus on careful Hamiltonian engineering, on a high level of abstraction to program the quantum circuits, and on efficient background calibration, all of which are essential to achieve high fidelities on this extended system. State preparation combines initialization by measurement and real-time feedback with quantum-non-demolition measurements. These advances will enable testing of increasingly meaningful quantum protocols and constitute a major stepping stone towards large-scale quantum computers.