The short-range structures of LiF-ThF4, NaF-AnF4, KF-AnF4, and Cs-AnF4 (An = Th, U), were probed using in situ high temperature Extended X-ray Absorption Fine Structure (EXAFS) spectroscopy. Signally, the EXAFS spectra of pure molten ThF4 and UF4 were measured for the first time. The data were interpreted with the aid of Molecular Dynamics (MD) and standard fitting of the EXAFS equation. As in related studies, a speciation distribution dominated by [AnFx]4-x (x = 7, 8, 9) coordination complexes was observed. The average coordination number was found to decrease with the increasing size of the alkali cation, and increase with AnF4 content. An average coordination number close to 6, which had not been detected before in melts of alkali actinide fluorides, was seen when CsF was used as solvent. This journal is

A method based on ultrasonic wave propagation is applied for the determination of the viscosity of low viscous liquids. A waveguide is used to remotely transmit the ultrasonic waves from a shear piezoelectric transducer into the liquid. At the solid-liquid interface, a guided wave mode, the shear mode, is used to extract the liquid viscosity. The energy of the reflected ultrasonic wave depends upon its operating frequency, the physical properties of the liquid (viscosity and density), and the waveguide (density and shear modulus). The results show that the attenuation of the waves, and thus the viscosity of the liquid, can be retrieved using this method. Measurements on water, ethanol, and mixtures of water/glycerol illustrate that the method can monitor changes in attenuation due to the viscosity of the liquid. The range of viscosities measured was between 0.8 and 60 mPa s. Compared to literature values, the relative error for these measurements was lower than 12% while the uncertainty in the measurements was lower than 5%. Besides its ability to measure low viscosities, this method offers advantages such as the capability to perform in-situ measurements of liquids in harsh environments, the omission of mechanical parts, and the possibility to handle small volumes of liquid. These features make this method suitable for low viscous liquids that are radioactive, corrosive and at high temperature.

The development at the Delft University of Technology (TU Delft, The Netherlands) of an experimental set-up dedicated to high-temperature in situ EXAFS measurements of radioactive, air-sensitive and corrosive fluoride salts is reported. A detailed description of the sample containment cell, of the furnace design, and of the measurement geometry allowing simultaneous transmission and fluorescence measurements is given herein. The performance of the equipment is tested with the room-temperature measurement of thorium tetrafluoride, and the Th—F and Th—Th bond distances obtained by fitting of the EXAFS data are compared with the ones extracted from a refinement of neutron diffraction data collected at the PEARL beamline at TU Delft. The adequacy of the sample confinement is checked with a mapping of the thorium concentration profile of molten salt material. Finally, a few selected salt mixtures (LiF:ThF₄) = (0.9:0.1), (0.75:0.25), (0.5:0.5) and (NaF:ThF₄) = (0.67:0.33), (0.5:0.5) are measured in the molten state. Qualitative trends along the series are discussed, and the experimental data for the (LiF:ThF₄) = (0.5:0.5) composition are compared with the EXAFS spectrum generated from molecular dynamics simulations.