A combined experimental and modelling study into the Pb-Mo-O system has been conducted in view of the safety analysis for lead-cooled nuclear systems. The thermal expansion and low-temperature heat capacity of the ternary compounds PbMoO4 and Pb2MoO5 have been determined experimentally, as well as the melting enthalpy of PbMoO4. Moreover, XANES measurements have confirmed the hexavalent oxidation state of Mo in PbMoO4 and Pb2MoO5.

A thermodynamic model of the ternary system including the ternary phases PbMoO4, Pb2MoO5 and Pb5MoO8 has also been developed in this work based on the CALPHAD methodology. For the first time, an ionic two-sublattice model is used for the liquid phase, while the compound energy formalism is used for the solid phases.@en

The quaternary compound Cs₂Pb(MoO₄)₂ was synthesized and its structure was characterized using X-ray and neutron diffraction from 298 to 773 K, while thermal expansion was studied from 298 to 723 K. The crystal structure of the high-temperature phase β-Cs₂Pb(MoO₄)₂ was elucidated, and it was found to crystallize in the space group R3̅m (No. 166), i.e., with a palmierite structure. In addition, the oxidation state of Mo in the low-temperature phase α-Cs₂Pb(MoO₄)₂ was studied using X-ray absorption near-edge structure spectroscopy. Phase diagram equilibrium measurements in the Cs₂MoO₄-PbMoO₄ system were performed, revisiting a previously reported phase diagram. The equilibrium phase diagram proposed here includes a different composition of the intermediate compound in this system. The obtained data can serve as relevant information for thermodynamic modeling in view of the safety assessment of next-generation lead-cooled fast reactors.

@en

© 2021 The Authors LiF-UF4 is a key binary system for molten fluoride reactor technology, which has not been scrutinized as thoroughly as the closely related LiF-ThF4 system. The phase diagram equilibria in the system LiF-UF4 are explored in this work with X-ray diffraction (XRD) and differential scanning calorimetry (DSC). The short-range ordering in the molten salt solution is moreover surveyed with Extended X-ray Absorption Fine Structure spectroscopy (EXAFS) and interpreted using a combination of standard fitting of the EXAFS data and Molecular Dynamics (MD) simulations with a Polarizable Ion Model (PIM) potential. The density, excess molar volume, thermal expansion, heat capacity, and enthalpy of mixing are extracted from the MD simulations across a range of temperatures and compositions; the behavior is non-ideal, with reasonably good agreement with the experimental data. Also calculated is the distribution of heteropolyanions in the liquid solution, and modelled using the quasi-chemical formalism in the quadruplet approximation taking into account the existence of the single-shell complexes [UF7]3−, [UF8]4−, and the dimeric species [U2F14]6−. Subjecting the optimization of the excess Gibbs energy parameters of the liquid solution to the constraints of the phase diagram data and local structure of the melt as derived from the EXAFS and coupled MD simulations, a CALPHAD-type assessment is proposed, linking structural and thermodynamic properties, with a rigorous physical description of the melt.@en

The short-range structures of LiF-ThF4, NaF-AnF4, KF-AnF4, and Cs-AnF4 (An = Th, U), were probed using in situ high temperature Extended X-ray Absorption Fine Structure (EXAFS) spectroscopy. Signally, the EXAFS spectra of pure molten ThF4 and UF4 were measured for the first time. The data were interpreted with the aid of Molecular Dynamics (MD) and standard fitting of the EXAFS equation. As in related studies, a speciation distribution dominated by [AnFx]4-x (x = 7, 8, 9) coordination complexes was observed. The average coordination number was found to decrease with the increasing size of the alkali cation, and increase with AnF4 content. An average coordination number close to 6, which had not been detected before in melts of alkali actinide fluorides, was seen when CsF was used as solvent. This journal is

@en

In the context of a comprehensive campaign for the characterisation of transmutation fuels for next generation nuclear reactors, the melting behaviour of mixed uranium-americium dioxides has been experimentally studied for the first time by laser heating, for Am concentrations up to 70 mol. % under different types of atmospheres. Extensive post-melting material characterisations were then performed by X-ray absorption spectroscopy and electron microscopy. The melting temperatures observed for the various compositions follow a markedly different trend depending on the experimental atmosphere. Uranium-rich samples melt at temperatures significantly lower (around 2700 K) when they are laser-heated in a strongly oxidizing atmosphere compressed air at (0.300 ± 0.005) MPa, compared to the melting points (beyond 3000 K) registered for the same compositions in an inert environment (pressurised Ar). This behaviour has been interpreted on the basis of the strong oxidation of such samples in air, leading to lower-melting temperatures. Thus, the melting temperature trend observed in air is characterized, in the purely pseudo-binary dioxide plane, by an apparent maximum melting temperature around 2850 K for 0.3 < x(AmO₂) < 0.5. The melting points measured under inert atmosphere uniformly decrease with increasing americium content, displaying an approximately ideal solution behaviour if a melting point around 2386 K is assumed for pure AmO₂. In reality, it will be shown that the (U, Am)-oxide system can only be rigorously described in the ternary U-Am-O phase diagram, rather than the UO₂-AmO₂ pseudo-binary, due to the aforementioned over-oxidation effect in air. Indeed, general departures from the oxygen stoichiometry (Oxygen/Metal ratios ≠ 2.0) have been highlighted by the X-ray Absorption Spectroscopy (XAS). Finally, to help interpret the experimental results, thermodynamic computations based on the CALPHAD method will be presented.

@en

To assure the safety of oxide-fuel based nuclear reactors, the knowledge of the atomic-scale properties of U_1−yM_yO_2±x materials is essential. These compounds show complex chemical properties, originating from the fact that actinides and rare earths may occur with different oxidation states. In these mostly ionic materials, aliovalent cationic configurations can induce changes in the oxygen stoichiometry, with dramatic effects on the properties of the fuel. First studies on U_1−yAm_yO_2±x indicated that these materials exhibit particularly complex electronic and local-structure configurations. Here we present an in-depth study of these compounds, over a wide compositional domain, by combining XRD, XAS and Raman spectroscopy. We provide evidences of the co-existence of four different cations (U⁴⁺, U⁵⁺, Am³⁺, Am⁴⁺) in U_1−yM_yO_2±x compounds, which nevertheless maintain the fluorite structure. Indeed, we show that the cationic sublattice is basically unaffected by the extreme multi-valence states, whereas complex defects are present in the oxygen sublattice.

@en

The development at the Delft University of Technology (TU Delft, The Netherlands) of an experimental set-up dedicated to high-temperature in situ EXAFS measurements of radioactive, air-sensitive and corrosive fluoride salts is reported. A detailed description of the sample containment cell, of the furnace design, and of the measurement geometry allowing simultaneous transmission and fluorescence measurements is given herein. The performance of the equipment is tested with the room-temperature measurement of thorium tetrafluoride, and the Th—F and Th—Th bond distances obtained by fitting of the EXAFS data are compared with the ones extracted from a refinement of neutron diffraction data collected at the PEARL beamline at TU Delft. The adequacy of the sample confinement is checked with a mapping of the thorium concentration profile of molten salt material. Finally, a few selected salt mixtures (LiF:ThF₄) = (0.9:0.1), (0.75:0.25), (0.5:0.5) and (NaF:ThF₄) = (0.67:0.33), (0.5:0.5) are measured in the molten state. Qualitative trends along the series are discussed, and the experimental data for the (LiF:ThF₄) = (0.5:0.5) composition are compared with the EXAFS spectrum generated from molecular dynamics simulations.

@en