The formation of a thin layer, the so-called Joint Oxyde-Gaine (JOG), between the (U,Pu)O2 fuel pellets and the cladding has been observed in fast neutron reactors, due to the accumulation of volatile fission products. Cs2MoO4 is known to be one of the major components of the JOG, but other elements are also present, in particular tellurium and palladium. In this work, an investigation of the structural and thermodynamic properties of Cs2TeO4 and Cs2Mo1-xTexO4 solid solution is reported. The existence of a complete solubility between Cs2MoO4 and Cs2TeO4 is demonstrated, combining X-ray diffraction (XRD), neutron diffraction (ND), and X-ray absorption spectroscopy (XAS) results. High-temperature XRD measurements were moreover performed on Cs2TeO4, which revealed the existence of a α-β phase transition around 712 K. Thermal expansion coefficients were also obtained from these data. Finally, phase equilibra points in the Cs2MoO4-Cs2TeO4 pseudobinary phase diagram were collected using differential scanning calorimetry and used to develop a thermodynamic model for this system using a regular solution formalism.

Neutron diffraction, X-ray absorption spectroscopy (XAS), and Raman spectroscopy measurements of the quaternary perovskite phase Ba₂NaMoO_5.5 have been performed in this work. The cubic crystal structure in space group Fm3¯ m has been refined using the Rietveld method. X-ray absorption near-edge structure spectroscopy (XANES) measurements at the Mo K-edge have confirmed the hexavalent state of molybdenum. The local structure of the molybdenum octahedra has been studied in detail using extended X-ray absorption fine structure (EXAFS) spectroscopy. The Mo-O and Mo-Ba distances have been compared to the neutron diffraction data with good agreement. The coefficient of thermal expansion measured in the temperature range of 303-923 K, using high temperature X-ray diffraction (HT-XRD) (α_V = 55.8 × 10^-6 K), has been determined to be ∼2 times higher than that of the barium molybdates BaMoO₃ and BaMoO₄. Moreover, no phase transition nor melting have been observed, neither by HT-XRD nor Raman spectroscopy nor differential scanning calorimetry, up to 1473 K. Furthermore, the standard enthalpy of formation (Δ_fH_m°) for Ba₂NaMoO_5.5(cr) has been determined to be -(2524.75 ± 4.15) kJ mol^-1 at 298.15 K, using solution calorimetry. Finally, the margin for safe operation of sodium-cooled fast reactors (SFRs) has been assessed by calculating the threshold oxygen potential needed, in liquid sodium, to form the quaternary compound, following an interaction between irradiated mixed oxide (U,Pu)O₂ fuel and sodium coolant.

In the context of a comprehensive campaign for the characterisation of transmutation fuels for next generation nuclear reactors, the melting behaviour of mixed uranium-americium dioxides has been experimentally studied for the first time by laser heating, for Am concentrations up to 70 mol. % under different types of atmospheres. Extensive post-melting material characterisations were then performed by X-ray absorption spectroscopy and electron microscopy. The melting temperatures observed for the various compositions follow a markedly different trend depending on the experimental atmosphere. Uranium-rich samples melt at temperatures significantly lower (around 2700 K) when they are laser-heated in a strongly oxidizing atmosphere compressed air at (0.300 ± 0.005) MPa, compared to the melting points (beyond 3000 K) registered for the same compositions in an inert environment (pressurised Ar). This behaviour has been interpreted on the basis of the strong oxidation of such samples in air, leading to lower-melting temperatures. Thus, the melting temperature trend observed in air is characterized, in the purely pseudo-binary dioxide plane, by an apparent maximum melting temperature around 2850 K for 0.3 < x(AmO₂) < 0.5. The melting points measured under inert atmosphere uniformly decrease with increasing americium content, displaying an approximately ideal solution behaviour if a melting point around 2386 K is assumed for pure AmO₂. In reality, it will be shown that the (U, Am)-oxide system can only be rigorously described in the ternary U-Am-O phase diagram, rather than the UO₂-AmO₂ pseudo-binary, due to the aforementioned over-oxidation effect in air. Indeed, general departures from the oxygen stoichiometry (Oxygen/Metal ratios ≠ 2.0) have been highlighted by the X-ray Absorption Spectroscopy (XAS). Finally, to help interpret the experimental results, thermodynamic computations based on the CALPHAD method will be presented.

To assure the safety of oxide-fuel based nuclear reactors, the knowledge of the atomic-scale properties of U_1−yM_yO_2±x materials is essential. These compounds show complex chemical properties, originating from the fact that actinides and rare earths may occur with different oxidation states. In these mostly ionic materials, aliovalent cationic configurations can induce changes in the oxygen stoichiometry, with dramatic effects on the properties of the fuel. First studies on U_1−yAm_yO_2±x indicated that these materials exhibit particularly complex electronic and local-structure configurations. Here we present an in-depth study of these compounds, over a wide compositional domain, by combining XRD, XAS and Raman spectroscopy. We provide evidences of the co-existence of four different cations (U⁴⁺, U⁵⁺, Am³⁺, Am⁴⁺) in U_1−yM_yO_2±x compounds, which nevertheless maintain the fluorite structure. Indeed, we show that the cationic sublattice is basically unaffected by the extreme multi-valence states, whereas complex defects are present in the oxygen sublattice.