Rare-earth (RE) oxyhydride thin films prepared by reactive magnetron sputtering followed by air-oxidation show a color-neutral photochromic effect at ambient conditions within a wide composition range (REOxH3-2x where 0.5 ≤ x < 1.5). Due to the high degree of anion sublattice disorder present in these thin films, the structure models proposed for the related bulk materials are not directly applicable. Instead we use a combination of EXAFS analysis and lattice energy calculations to establish a fcc-based model linking the oxyhydrides to the related binary compounds. The oxide anions are found to occupy predominantly the tetrahedral sites in the fcc structure, which is attributed to electrostatic lattice energy minimization.

X-ray absorption and small-angle x-ray scattering spectra were simultaneously acquired under operando conditions in a joined technique approach, for the first time applied in the field of energy storage materials. This approach allows one to closely follow the electronic and local structure evolution, as well as monitor and quantify the morphological and nanostructural changes occurring during electrochemical cycling. Here we demonstrate its potential on the example of doped and non-doped Fe₂O₃ anode material vs. Li. Our results reveal that upon discharge Fe³⁺ is gradually reduced to the metallic state and segregated as nanoparticles. For the relithiation reaction, upon subsequent charge, we observe improved reversibility for the Sr-doped compared to non-doped and Ca-doped Fe₂O₃. We highlight that this combined technique approach is a reliable, facile and powerful tool to investigate electrode materials under realistic cycling condition. It provides an unbiased and holistic picture of the morphological and structural changes occurring during operation, which allows for adequate material tailoring.

X-ray absorption spectroscopy (XAS) offers the unique possibility to study metal electrocatalysts such as silver and copper while they are performing electrochemical carbon dioxide (CO2) reduction. In this work, we present an approach to perform operando XAS experiments on an electrochemical cell performing CO2 reduction with a gas diffusion electrode (GDE) as cathode. The experimental set-up, advantages and drawbacks, XAS data analysis, and XAS theory are discussed. Results on copper and silver GDEs obtained through the presented procedures are then presented and discussed. Structural and compositional catalyst data acquired under operando conditions can help further density functional theory calculations, and catalytic, and systems studies on CO2 reduction. Structural and compositional data including crystallite size were obtained while performing high current density (up to 200 mA cm-2) CO2 reduction. On the silver catalysts at higher than 100 mA cm-2 applied current density, a Ag-X contribution was found and is ascribed to Ag-O. For both silver and copper, the XAS experiments revealed that the crystallite size of the ex situ samples is smaller than the samples during CO2 reduction. Furthermore, metal particle size polydispersity was found in the silver catalysts by comparing the obtained coordination numbers with theoretical values. The operando EXAFS data was of such high quality (k: 3-14 Å-1) that four shells could be fitted. The value of combining ex situ material characterisation and electrocatalyst performance data with operando XAS experiments is discussed and found to be of great importance to further CO2 reduction research.

Zinc is routinely employed in the synthesis of InP quantum dots (QDs) to improve the photoluminescence efficiency and carrier mobility of the resulting In(Zn)P alloy nanostructures. The exact location of Zn in the final structures and the mechanism by which it enhances the optoelectronic properties of the QDs are debated. We use synchrotron X-ray absorbance spectroscopy to show that the majority of Zn in In(Zn)P QDs is located at their surface as Zn carboxylates. However, a small amount of Zn is present inside the bulk of the QDs with the consequent contraction of their lattice, as confirmed by combining high-resolution high-angle annular dark-field imaging scanning transmission electron microscopy with statistical parameter estimation theory. We further demonstrate that the Zn content and its incorporation into the QDs can be tuned by the ligation of commonly employed Zn carboxylate precursors: the use of highly reactive Zn acetate leads to the formation of undesired Zn₃P₂ and the final nanostructures being characterized by broad optical features, whereas Zn carboxylates with longer carbon chains lead to InP crystals with much lower zinc content and narrow optical features. These results can explain the differences between structural and optical properties of In(Zn)P samples reported across the literature and provide a rational method to tune the amount of Zn in InP nanocrystals and to drive the incorporation of Zn either as surface Zn carboxylate, as a substitutional dopant inside the InP crystal lattice, or even predominantly as Zn₃P₂.

To this day, elucidating the charge transfer process in electrode materials upon electrochemical cycling remains a challenge, primarily due to the complexity of chemical reactions at the electrode surfaces. Here, we present an elegant and reliable method to probe bulk-sensitive soft edges for elucidating anodic and cathodic charge compensation contribution via X-ray Raman scattering spectroscopy. By using a hard X-ray incident beam, this technique circumvents surface limitations and is practically free of self-absorption due to its nonresonant nature. In addition, it does not require complex sample preparation or experimental setups, making it an ideal tool for potential in situ analysis of the electronic structure of electrode materials. In this study, we monitored, for the first time, bulk soft edges of both oxygen and transition metal (iron) of the cathode material Li₂FeSiO₄ during one complete electrochemical cycle concurrently. Our results reveal that the redox mechanism relies primarily on the iron (cathodic) contribution. Nevertheless, a change in electron confinement of the oxygen suggests its active involvement in the charge compensation process (anodic). Moreover, we were able to support the experimentally observed changes in the electronic structure with ab initio-based simulation.

Photocharging has recently been demonstrated as a powerful method to improve the photoelectrochemical water splitting performance of different metal oxide photoanodes, including BiVO₄. In this work, we use ambient-pressure X-ray Raman scattering (XRS) spectroscopy to study the surface electronic structure of photocharged BiVO₄. The O K edge spectrum was simulated using the finite difference method near-edge structure program package, which revealed a change in electron confinement and occupancy in the conduction band. These insights, combined with ultraviolet-visible spectroscopy and X-ray photoelectron spectroscopy analyses, reveal that a surface layer formed during photocharging creates a heterojunction with BiVO₄, leading to favorable band bending and strongly reduced surface recombination. The XRS images presented in this work exhibit good agreement with soft X-ray absorption near-edge structure spectra from the literature, demonstrating that XRS is a powerful tool to study the electronic and structural properties of light elements in semiconductors. Our findings provide direct evidence of the electronic modification of a metal oxide photoanode surface as a result of the adsorption of electrolyte anionic species under operating conditions. This work highlights that the surface adsorption of these electrolyte anionic species is likely present in most studies on metal oxide photoanodes and has serious implications for the photoelectrochemical performance analysis and fundamental understanding of these materials.

Electrocatalysis of carbon dioxide can provide a valuable pathway towards the sustainable production of chemicals and fuels from renewable electricity sources. One of the main challenges to enable this technology is to find suitable electrodes that can act as efficient, stable and selective CO₂ reduction catalysts. Modified silver catalysts and in particular, catalysts electrochemically derived from silver-oxides, have shown great promise in this regard. Here, we use operando EXAFS analysis to study the differences in surface composition between a pure silver film and oxide-derived silver catalysts-a nanostructured catalyst with improved CO₂ reduction performance. The EXAFS analysis reveals the presence of trace amounts of oxygen in the oxide-derived silver samples, with the measured oxygen content correlating well with experimental studies showing an increase in CO₂ reduction reactivity towards carbon monoxide. The selectivity towards CO production also partially scales with the increased surface area, showing that the morphology, local composition and electronic structure all play important roles in the improved activity and selectivity of oxide-derived silver electrocatalysts. Earlier studies based on X-ray photoelectron spectroscopy (XPS) were not able to identify this oxygen, most likely because in ultra-high vacuum conditions, silver can self-reduce to Ag⁰, removing existing oxygen species. This operando EXAFS study shows the potential for in situ and operando techniques to probe catalyst surfaces during electrolysis and aid in the overall understanding of electrochemical systems.

The processes that govern radiative recombination in ternary CuInS₂ (CIS) nanocrystals (NCs) have been heavily debated, but recently, several research groups have come to the same conclusion that a photoexcited electron recombines with a localized hole on a Cu-related trap state. Furthermore, it has been observed that single CIS NCs display narrower photoluminescence (PL) line widths than the ensemble, which led to the conclusion that within the ensemble there is a distribution of Cu-related trap states responsible for PL. In this work, we probe this trap-state distribution with in situ photoluminescence spectroelectrochemistry. We find that Cu²⁺ states result in individual "dark" nanocrystals, whereas Cu⁺ states result in "bright" NCs. Furthermore, we show that we can tune the PL position, intensity, and line width in a cyclic fashion by injecting or removing electrons from the trap-state distribution, thereby converting a subset of "dark" Cu²⁺ containing NCs into "bright" Cu⁺ containing NCs and vice versa. The electrochemical injection of electrons results in brightening, broadening, and a red shift of the PL, in line with the activation of a broad distribution of "dark" NCs (Cu²⁺ states) into "bright" NCs (Cu⁺ states) and a rise of the Fermi level within the ensemble trap-state distribution. The opposite trend is observed for electrochemical oxidation of Cu⁺ states into Cu²⁺. Our work shows that there is a direct correlation between the line width of the ensemble Cu⁺/Cu²⁺ trap-state distribution and the characteristic broad-band PL feature of CIS NCs and between Cu²⁺ cations in the photoexcited state (bright) and in the electrochemically oxidized ground state (dark).

Bismuth vanadate (BiVO₄) is one of the most efficient light absorbing metal oxides for solar water splitting. BiVO₄ photoanodes immersed in an electrolyte in an open circuit configuration and exposed to simulated solar illumination for prolonged time achieve superior photoelectrochemical (PEC) activity. This photocharging (PC) effect is capable of almost completely overcoming the surface and bulk limitations of BiVO₄. Herein we show that alkaline conditions favor the PC effect; specifically BiVO₄ photoanodes subjected to PC treatment at pH 10 achieve a record high photocurrent for undoped and uncatalyzed BiVO₄ of 4.3 mA cm^-2 @ 1.23 V_RHE, an outstandingly low onset potential of 0.25 V_RHE, and a very steep photocurrent onset. Alkaline conditions also facilitate excellent external and internal quantum efficiencies of 75 and 95% respectively (average in the 440 nm > λ > 330 nm range). Moreover, impedance spectroscopy and in situ XAS study suggest that electronic, structural and chemical properties of the bulk of these films remain unchanged during the PC treatment. However, appreciable changes in the surface-related properties take place. Ultimately, our results indicate that the improved activity of PC-BiVO₄ is enhanced by surface reaction pathways of the semiconductor-liquid junction, which is directly correlated with the electrochemical environment in which it is modified.

Hydrogen is a key element in the energy transition. Hydrogen-metal systems have been studied for various energy-related applications, e.g., for their use in reversible hydrogen storage, catalysis, hydrogen sensing, and rechargeable batteries. These applications depend strongly on the thermodynamics of the metal-hydrogen system. Therefore, tailoring the thermodynamics of metal-hydrogen interactions is crucial for tuning the properties of metal hydrides. Here we present a case of large metal hydride destabilization by elastic strain. The addition of small amounts of zirconium to yttrium leads to a compression of the yttrium lattice, which is maintained during (de)hydrogenation cycles. As a result, the equilibrium hydrogen pressure of YH₂ → YH₃ can be rationally and precisely tuned up to five orders of magnitude at room temperature. This allows us to realize a hydrogen sensor which indicates the ambient hydrogen pressure over four orders of magnitude by an eye-visible color change.