Aqueous foams play an important role in many industrial processes, from ore separation by froth flotation to enhanced oil recovery (EOR), where the foam is used as a means of increasing sweep efficiency through oil-bearing rock. The complex, structure-dependent, flow behavior of the foam gives improved penetration of lower-permeability regions. Foam is stabilized by surfactant molecules, and the foam strength is influenced by the surfactant concentration in the water phase. It is therefore of great importance to understand the effect of surfactant concentration on foam processes. Implicit Texture (IT) foam models eg STARS account for the surfactant effect with functions that depend on surfactant concentration in the water and a few other parameters. However, there is no evidence that these functions are able to capture adequately the effect of surfactant concentration effect. We present a comparative study of foam core-flood experiments with various surfactant concentrations. Core-flood tests were conducted in rock cores with a diameter of 1 cm and length of 17cm, significantly smaller than typical cores. Plots of apparent viscosity vs. injected gas fraction were obtained for surfactant concentrations at the critical micellar concentration (CMC) and above. Bulk foam stability and surface tension were measured for all concentrations, in order to define the CMC and to compare with coreflood results. The experimental results have been matched with the STARS IT foam model and the dependency of model parameters on the surfactant concentration is discussed. This work found that the IT model is not able to predict the decrease of the foam strength with decreasing surfactant concentration. Instead, the study shows that the effect of surfactant concentration can be correlated with the dry-out function of the IT model, and specifically to the limiting capillary pressure.@en

We present a comparative study of foam coreflood experiments with various surfactant concentrations. Plots of apparent viscosity vs. injected gas fraction were obtained for surfactant concentrations at the critical micelle concentration and above. Bulk foam stability was measured for all concentrations and compared with the coreflood results. There were different responses to surfactant concentration in bulk and in corefloods. The coreflood results were matched with an implicit-texture foam model, and the dependency of the model parameters on the surfactant concentration is discussed. Fitting the data requires relating the surfactant concentration to the dry-out function or the limiting capillary pressure. @en