Advances in far infrared astronomy have been, and will be, defined by instrument capabilities. Especially relevant is the development of imaging spectrometers for the wavelength range of 0.03-3 mm, which are not available at all at this moment. We will discuss recent advances in this field: First, we discuss the development of miniature on-chip spectrometers, that can operate in a 0.09-1 THz by using lossless superconducting circuits to create miniature spectrometers. For higher frequencies this is not possible due to material limitations, moreover instruments have to be operated in space due to the opacity of the atmosphere. Recent proposals for new missions focus on space-based observatories with optics cooled down to 4K, which offer unprecedented spectral imaging speeds, but require large arrays of extremely sensitive detectors. In the second part of this paper we will discuss the development of microwave Kinetic Inductance detectors with a sensitivity of NEP. 3.1.10-20 W/ãHz, sufficient for these applications.@en

A focal plane array of extended-hemispherical silicon lenses coupled to aluminum coplanar-waveguide (CPW) Microwave Kinetic Inductance Detectors (MKIDs) has been designed to operate at 7.8 THz. Low-dispersive leaky-wave radiation has been used to efficiently illuminate the antireflection-coated lenses. To minimize the radiation loss from the antenna feeding lines at these high frequencies, the CPWs have been miniaturized and placed on a dielectric membrane. A test device has been fabricated and its experimental characterization in terms of sensitivity, optical coupling, and beam patterns is ongoing.@en

With increasing array size, it is increasingly important to control stray radiation inside the detector chips themselves. We demonstrate this effect with focal plane arrays of absorber coupled Lumped Element microwave Kinetic Inductance Detectors (LEKIDs) and lens-antenna coupled distributed quarter wavelength Microwave Kinetic Inductance Detectors (MKIDs). In these arrays the response from a point source at the pixel position is at a similar level to the stray response integrated over the entire chip area. For the antenna coupled arrays, we show that this effect can be suppressed by incorporating an on-chip stray light absorber. A similar method should be possible with the LEKID array, especially when they are lens coupled.

@en

The development of astrophysics kilo-pixel imaging systems requires a dedicated cryogenics and optics setup to measure the performance of the detector arrays in terms of sensitivity, crosstalk, dynamic range, and spatial response. We have developed such testbed for the characterization of large format arrays of microwave kinetic inductance detectors (MKIDs), capable of measuring detector chips of 6 cm × 6 cm, operating in the 350 and 850 GHz band. The testbed is a wide field camera that produces an aberration free image of the chip outside of the cryostat. The cryostat is based upon a commercial pulse-tube cooled 3 K system with an He3-He3-He4 sorption cooler that reaches a base temperature below 250 mK. We will describe the thermomechanical solutions implemented in our system to minimize the thermal loading on the cold stage, needed to reach the low base temperature. We will also give the optical design including straylight control.

@en

Next generation sub-mm imaging instruments require kilo-pixel focal plane arrays filled with background limited detectors. Microwave kinetic inductance detectors (MKIDs) are a state-of-the-art detector for future instruments due to their inherent multiplexing capabilities. An MKID consists of a superconducting resonator coupled to a feed-line that is used for readout. In the device presented here radiation coupling is achieved by coupling the MKID directly to a planar antenna. The antenna is placed in the focus of an extended hemispherical lens to increase the filling factor and to match efficiently to fore optics. In this paper, we present the design and the optical performance of MKIDs optimized for operation in a 100-GHz band around 850 GHz. We have measured the coupling efficiency, frequency response, and beam patterns and compare those results to simulated performance. We obtain an excellent agreement between the measured and simulated beam pattern, frequency response, and absolute coupling efficiency between a thermal calibration source and the power absorbed in the detector. Additionally, we demonstrate that antenna coupled MKIDs offer background limited radiation detection down to ∼100 aW of power absorbed in the detector.

@en

We present results from the first vector beam pattern measurement of microwave kinetic inductance detectors (MKIDs). Vector beam patterns require sampling of the E-field of the receiver in both amplitude and phase. MKIDs are inherently direct detectors and have no phase response to incoming radiation. We map the amplitude and phase patterns of the detector beam profile by adapting a two-source heterodyne technique. Our testing strategy recovers the phase information by creating a reference signal to trigger data acquisition. The reference is generated by mixing the slightly offset low-frequency signals from the output of the two synthesizers used to drive the submillimeter sources. The key requirement is that the time-series record always begins at the same set phase of the reference signal. As the source probe is scanned within the receiver beam, the wavefront propagation phase of the receiver changes and causes a phase offset between the detector output and reference signals. We demonstrated this technique on the central pixel of a test array operating at 350 GHz. This methodology will enable vector beam pattern measurements to be performed on direct detectors, which have distinct advantages reducing systematic sources of error, allowing beam propagation, and removing the far-field measurement requirement such that complicated optical systems can be measured at a point that is easily accessible, including the near field.@en

Large ultrasensitive detector arrays are needed for present and future observatories for far infrared, submillimeter wave (THz), and millimeter wave astronomy. With increasing array size, it is increasingly important to control stray radiation inside the detector chips themselves, the surface wave. We demonstrate this effect with focal plane arrays of 880 lens-antenna coupled microwave kinetic inductance detectors (MKIDs). Presented here are near field measurements of the MKID optical response versus the position on the array of a reimaged optical source. We demonstrate that the optical response of a detector in these arrays saturates off-pixel at the ∼-30-dB level compared to the peak pixel response. The result is that the power detected from a point source at the pixel position is at a similar level to the stray response integrated over the chip area. With such a contribution, it would be impossible to measure extended sources, while the point source sensitivity is degraded due to an increase of the stray loading. However, we show that by incorporating an on-chip stray light absorber, the surface wave contribution is reduced by a factor >10. With the on-chip stray light absorber, the point source response is close to simulations down to the ∼ -35-dB level, the simulation based on an ideal Gaussian illumination of the optics. In addition, as a crosscheck, we show that the extended source response of a single pixel in the array with the absorbing grid is in agreement with the integral of the point source measurements.

@en

Microwave Kinetic Inductance Detectors (MKIDs) are becoming a very promising candidate for next generation imaging instruments for the far infrared. A MKID consists of a superconducting resonator coupled to a feed-line used for the readout. In the devices presented here radiation coupling is achieved by coupling the MKID directly to planar antenna. The antenna is placed in the focus of an elliptical lens to increase the filling factor and to match efficiently to fore-optics. In this paper we present the design and the optical performance of MKIDs optimized for operation at 350 GHz. We have measured a device consisting of 14 pixels, characterized the coupling efficiency, antenna-lens frequency response and beam pattern and compared these to theoretical simulations. The optical efficiency has been measured by means of a black body radiator mounted in an ADR cryostat, through the variation of the black body temperature a variable illumination of each pixel (from 0.1 fW to 2 pW) is achieved. The frequency response and beam pattern have been directly measured in a He3 cryostat directly via the cryostat window and without the use of intermediate optics.

@en