Electrochemical ammonia (NH₃) synthesis from nitrate (NO₃⁻) offers a promising greener alternative to the fossil-fuel-based Haber-Bosch process to support the increasing demand for nitrogen fertilizers while removing environmental waste. Previous studies have mainly focused on designing catalysts to promote the direct conversion (NO₃⁻ → NH₃) while suppressing the two-step pathway (NO₃⁻ → NO₂⁻ → NH₃). We hypothesize that efficient nitrate reduction is possible on simple catalysts by instead promoting the two-step reaction and using chemical reactor principles in a membrane electrode assembly, despite NO₂⁻ intermediates. Here, we use an unmodified copper catalyst and control reactivity through current density, flow rate, and electrolyte recycling. Balancing the electrolyte flow rate with current density results in ideal residence times for NO₂⁻, allowing for 91% FE_NH3 in a 5 cm² electrolyzer with a NO₃⁻ to NH₃ partial current of 1.8 A. This work shows that traditional engineering principles can substantially boost the NO₃ reduction reaction, even for simple catalysts.

@en

Using copper (Cu) as an electrocatalyst uniquely produces multicarbon products (C₂₊-products) during the CO₂ reduction reaction (CO2RR). However, the CO2RR stability of Cu is presently 3 orders of magnitude shorter than required for commercial operation. One means of substantially increasing Cu catalyst lifetimes is through periodic oxidative processes, such as cathodic-anodic pulsing. Despite 100-fold improvements, these oxidative methods only delay, but do not circumvent, degradation. Here, we provide an interrogation of chemical and electrochemical Cu oxidative processes to identify the mechanistic processes leading to stable CO2RR through electrochemical and in situ Raman spectroscopy measurements. We first examine chemical oxidation using an open-circuit potential (OCP), identifying that copper oxidation is regulated by the transient behavior of the OCP curve and limited by the rate of the oxygen reduction reaction (ORR). Increasing O₂ flux to the cathode subsequently increased ORR rates, both extending lifetimes and reducing “off” times by 3-fold. In a separate approach, the formation of Cu₂O is achieved through electrochemical oxidation. Here, we establish the minimum electrode potentials required for fast Cu oxidation (−0.28 V vs Ag/AgCl, 1 M KHCO₃) by accounting for transient local pH changes and tracking oxidation charge transfer. Lastly, we performed a stability test resulting in a 20-fold increase in stable ethylene production versus the continuous case, finding that spatial copper migration is slowed but not mitigated by oxidative pulsing approaches alone.

@en

Carbon dioxide (CO2) electrolysis on copper (Cu) catalysts has attracted interest due to its direct production of C2+ feedstocks. Using the knowledge that CO2 reduction on copper is primarily a tandem reaction of CO2 to CO and CO to C2+ products, we show that modulating CO concentrations within the liquid catalyst layer allows for a C2+ selectivity of >80% at 200 mA cm−2 under broad conversion conditions. The importance of CO pooling is demonstrated through residence time distribution curves, varying flow fields (serpentine/parallel/interdigitated), and flow rates. While serpentine flow fields require high conversions to limit CO selectivity and maximize C2+ selectivity, the longer CO residence times of parallel flow fields achieve similar selectivity over broad flow rates. Critically, we show that parts of the catalyst area predominantly reduce CO instead of CO2 as supported by CO reduction experiments, transport modelling, and achieving a CO2 utilization efficiency greater than the theoretical limit of 25% for C2+ products.@en