Superconducting resonators enable fast characterization and readout of mesoscopic quantum devices. Finding ways to perform measurements of interest on such devices using resonators only is therefore of great practical relevance. We report an experimental investigation of an InAs nanowire multiquantum dot device by probing gigahertz resonators connected to the device. First, we demonstrate accurate extraction of the dc conductance from measurements of the high-frequency admittance. Because our technique does not rely on dc calibration, it could potentially obviate the need for dc measurements in semiconductor qubit devices. Second, we demonstrate multiplexed gate sensing and the detection of charge tunneling on microsecond timescales. The gigahertz detection of dispersive resonator shifts allows rapid acquisition of charge stability diagrams, as well as resolving charge tunneling in the device with a signal-to-noise ratio of up to 15 in 1μs. Our measurements show that gigahertz-frequency resonators may serve as a universal tool for fast tuneup and high-fidelity readout of semiconductor qubits.@en

We report direct detection of charge tunneling between a quantum dot and a superconducting island through radio-frequency gate sensing. We are able to resolve spin-dependent quasiparticle tunneling as well as two-particle tunneling involving Cooper pairs. The quantum dot can act as an RF-only sensor to characterize the superconductor addition spectrum, enabling us to access subgap states without transport. Our results provide guidance for future dispersive parity measurements of Majorana modes, which can be realized by detecting the parity-dependent tunneling between dots and islands.

@en

Dispersive sensing is a powerful technique that enables scalable and high-fidelity readout of solid-state quantum bits. In particular, gate-based dispersive sensing has been proposed as the readout mechanism for future topological qubits, which can be measured by single electrons tunneling through zero-energy modes. The development of such a readout requires resolving the coherent charge tunneling amplitude from a quantum dot in a Majorana-zero-mode host system faithfully on short time scales. Here, we demonstrate rapid single-shot detection of a coherent single-electron tunneling amplitude between InAs nanowire quantum dots. We realize a sensitive dispersive detection circuit by connecting a sub-GHz, lumped-element microwave resonator to a high-lever arm gate on one of the dots. The resulting large dot-resonator coupling leads to an observed dispersive shift that is of the order of the resonator linewidth at charge degeneracy. This shift enables us to differentiate between Coulomb blockade and resonance - corresponding to the scenarios expected for qubit-state readout - with a signal-to-noise ratio exceeding 2 for an integration time of 1μs. Our result paves the way for single-shot measurements of fermion parity on microsecond time scales in topological qubits.

@en