This paper aims to investigate, by means of Lattice-Boltzmann simulations, the flow-field and far-field noise of two co-axial co-rotating rotors operating at 3000 rpm in hover conditions. The two co-rotating configurations are made by 2×2-bladed rotors with a fixed axial separation and two different azimuthal separations Δϕ equal to 84∘ and 12∘. Isolated 2- and 4-bladed rotors, are also simulated at the same operating conditions and used as aerodynamic and aeroacoustic reference. For both Δϕ=84∘ and 12∘, the upper rotor tip vortices are accelerated downstream due to the induction from the lower rotor, avoiding blade vortex interaction (BVI). The lower rotor tip vortices convect into the wake with a lower velocity, causing BVI for Δϕ=12∘. The lower rotor shows a reduction of thrust, relative to the upper rotor, of 36% and 66% for Δϕ=84∘ and 12∘, respectively. For Δϕ=12∘, the lower blades act as a wing flap for the upper ones, increasing their thrust. The tonal noise emission for the co-rotating rotors is driven by the interference between the acoustic waves from upper and lower rotors. Because of destructive interference, the configuration Δϕ=84∘ shows a first harmonic up to 15 dB lower than Δϕ=12∘, but still 4.5 dB higher than the isolated 4-bladed rotor.@en

This study investigates the impact of struts and a central tower on the aerodynamics and aeroacoustics of Darrieus Vertical Axis Wind Turbines (VAWTs) at chord-based Reynolds numbers of 8.12 × 104. A 2-bladed H-Darrieus VAWT is used, featuring a 1.5m diameter, a solidity of 0.1 and a blade cross-section of symmetrical NACA 0021. The turbine design is kept simple and straight-bladed which is essential for isolating and analyzing the specific effects of struts and a tower. The high-fidelity Lattice Boltzmann Method (LBM) in PowerFLOW 6-2020 and the mid-fidelity Lifting Line Free Vortex Wake (LLFVW) method in QBlade 2.0 are employed, with the mid-fidelity method providing a faster analytical tool for insights into the turbine performance. Firstly, both the LLFVW (mid-fidelity) and LBM (high-fidelity) methods effectively capture the general trends observed in VAWT power performance. However, the former predicts mean thrust values that are approximately 10% higher, and mean torque values that are approximately 19% higher, in comparison to the latter. Subsequently, the former predicts lower streamwise wake velocities relative to those predicted by the latter. These differences increase in configurations that include struts and a tower (to 30% - 31%). Secondly, the presence of struts and a tower leads to a reduction in both mean power (by 15% to 55%) and thrust (by 3% to 3.6%), with a further small decrease observed when doubling the tower diameter (power and thrust both by 0.5% to 3%). The struts predominantly affect the spanwise distribution of blade loading, while the tower impacts the azimuthal variation of blade loading. Additionally, the addition of struts and a tower reduces low-frequency noise (50-200 Hz) while increasing high-frequency noise (> 300 Hz). The observed decrease in mean blade loading results in reduced low-frequency noise, while the increase in high-frequency noise is ascribed to the increased intensity of BWI/BVI leading to higher unsteady loading fluctuations on blades.

@en