This article presents a data-compressive neural recording IC for single-cell resolution high-bandwidth brain–computer interfaces (BCIs). The IC features wired-OR lossy compression during digitization, thus preventing data deluge and massive data movement. By discarding unwanted baseline samples of the neural signals, the output data rate is reduced by 146× on average while allowing the reconstruction of spike samples. The recording array consists of pulse-position modulation (PPM)-based active digital pixels (ADPs) with a global single-slope (SS) analog-to-digital conversion scheme, which enables a low-power and compact pixel design with significantly simple routing and low array readout energy. Fabricated in a 28-nm CMOS process, the neural recording IC features 1024 channels (i.e., 32 × 32 array) with a pixel pitch of 36 µm that can be directly matched to a high-density micro-electrode array (MEA). The pixel achieves 7.4-µV_rms input-referred noise with a −3-dB bandwidth of 300 Hz–5 kHz while consuming only 268 nW from a single 1-V supply. The IC achieves the smallest area per channel (36 × 36 µm²) and the highest energy efficiency among the state-of-the-art neural recording ICs published to date.

@en

This paper presents a neural recording IC featuring lossy compression during digitization, thus preventing data deluge and enabling a compact active digital pixel design. The wired-OR-based compression discards unwanted baseline samples while allowing the reconstruction of spike samples. The IC features a 32x32 MEA with 36 μ m pixel pitch and consumes 268nW per pixel from a single 1V supply. It achieves 9.8 μ VRMS input-referred noise and 0.3-5kHz bandwidth, resulting in NEF/PEF of 3.7/14.1.

@en

Future high-density and high channel count neural interfaces that enable simultaneous recording of tens of thousands of neurons will provide a gateway to study, restore and augment neural functions. However, building such technology within the bit-rate limit and power budget of a fully implantable device is challenging. The wired-OR compressive readout architecture addresses the data deluge challenge of a high channel count neural interface using lossy compression at the analog-to-digital interface. In this article, we assess the suitability of wired-OR for several steps that are important for neuroengineering, including spike detection, spike assignment and waveform estimation. For various wiring configurations of wired-OR and assumptions about the quality of the underlying signal, we characterize the trade-off between compression ratio and task-specific signal fidelity metrics. Using data from 18 large-scale microelectrode array recordings in macaque retina ex vivo, we find that for an event SNR of 7-10, wired-OR correctly detects and assigns at least 80% of the spikes with at least 50× compression. The wired-OR approach also robustly encodes action potential waveform information, enabling downstream processing such as cell-type classification. Finally, we show that by applying an LZ77-based lossless compressor (gzip) to the output of the wired-OR architecture, 1000× compression can be achieved over the baseline recordings.

@en

This paper investigates the efficacy of a wired-OR compressive readout architecture for neural recording, which enables simultaneous data compression of action potential signals for high channel count electrode arrays. We consider a range of wiring configurations to assess the trade-offs between compression ratio and various task-specific signal fidelity metrics. We consider the fidelity in threshold crossing detection, spike assignment, and waveform estimation, and find that for an event SNR of 7-10 the readout captures at least 80% of the spike waveforms at ∼150x data compression.@en

Neural interfaces of the future will be used to help restore lost sensory, motor, and other capabilities. However, realizing this futuristic promise requires a major leap forward in how electronic devices interface with the nervous system. Next generation neural interfaces must support parallel recording from tens of thousands of electrodes within the form factor and power budget of a fully implanted device, posing a number of significant engineering challenges. In this paper, we exploit sparsity and diversity of neural signals to achieve simultaneous data compression and channel multiplexing for neural recordings. The architecture uses wired-OR interactions within an array of single-slope A/D converters to obtain massively parallel digitization of neural action potentials. The achieved compression is lossy but effective at retaining the critical samples belonging to action potentials, enabling efficient spike sorting and cell type identification. Simulation results of the architecture using data obtained from primate retina ex-vivo with a 512-channel electrode array show average compression rates up to  ∼ 40× while missing less than 5% of cells. In principle, the techniques presented here could be used to design interfaces to other parts of the nervous system.

@en

This paper describes an architecture for the massively parallel digitization of neural action potentials. The scheme achieves simultaneous data compression and channel multiplexing through wired-OR interactions within an array of single-slope A/D converters. The achieved compression is lossy but effective at retaining the critical samples belonging to action potential spikes. Simulation results using ex-vivo experimental data from a 512-channel array show compression rates up to ∼73x while maintaining ≥90% reconstruction coverage for parasol cells in the primate retina.

@en