Synchronized switch harvesting on inductor (SSHI) is an efficient active rectifier to extract energy generated from piezoelectric transducer in piezoelectric energy harvesting system. Unlike passive rectifiers, SSHI rectifiers require a power supply to drive synchronized switches. Unfortunately, there is no stable supply when the system starts from the cold state. Most designs let the system work as a passive full bridge rectifier (FBR) to charge power capacitor until a supply is available. However, a FBR requires high open-circuit voltage (VOC) and the FBR’s output voltage cannot go over VOC. This prevents the system from starting the SSHI rectifier if VOC is low. This paper proposes a new transducer reconfiguration design to lower the required VOC by 4 $\times$ to start up the SSHI system from the cold state. The proposed system is designed in a 0.18$-\mu$m BCD process and post-layout simulations show that the successful cold-startup under low VOC voltage.@en

Ultrasonic wireless power transfer (WPT) has been proved to be a promising approach to power biomedical implants. To extract the energy generated from the transducer, a rectifier is typically required. Previous inductor-based rectifiers (SSHI and SECE) require a large off-chip inductor to achieve good performance, which is not desired for miniaturization and safety reasons. Synchronized switch harvesting on capacitors (SSHC) rectifiers have been proved to achieve high performance without inductors; however, they are mainly designed for low-frequency kinetic energy harvesting. In this paper, an improved SSHC rectifier is designed to achieve a fully integrated design with all flying capacitors implemented on-chip. The proposed SSHC rectifier can properly operate at ultrasonic excitation frequency (100 KHz) with precise switching time control and ultrafast voltage flipping techniques. In addition, an on-chip ultralow-power LDO allows the system to be self-sustained. The system is designed in a TSMC 180nm BCD technology and post-layout simulation results are presented.@en