Traditionally, nadir-looking satellite radar altimeters provide water levels of rivers only at intersections with the satellite's ground track, called virtual stations. These observations have limited spatial coverage because such cross-overs are sparse, depending on the altimeter's orbit. In this work, we introduce the novel concept of Polygon-Informed Cross-Track Altimetry (PICTA), enabling accurate estimation of water levels at cross-track distances — for as long as the target's signal is recorded in the altimeter's range window. Using fully-focused SAR data from the Sentinel-6 altimetry mission, we demonstrate how the new approach can provide detailed river water level profiles over a ground swath of about 14 km cross-track width and with an along-track resolution as fine as 10 m. On the one hand, this marks a drastic improvement in the number of available measurements when compared to the virtual station approach, on the other hand, for the first time, water surface slopes and level variations along the river, caused by rapids, dams, and sluices, can be directly observed using a nadir radar altimeter. The validation over two river segments in France reveals biases as low as ±4 cm and random errors on the order of 3–8 cm at 30 m along-track resolution. The new PICTA concept can potentially be generalized to other targets, such as lakes or even coastlines.

@en

Until recently, intensity modulations in synthetic aperture radar (SAR) altimetry waveform tails have been considered a nuisance for geophysical-parameter retrieval. These modulations are actually predictable and might be exploited using a spectral analysis of the waveform tails. After Altiparmaki et al. (2022), a more elaborated analysis is performed to improve the interpretation of these SAR altimeter spectra. A fast numerical model is developed to explain the modulation mechanisms in focused SAR altimetry waveform tails. Using numerical solutions, standard analytical closed-form solutions, are demonstrated to be invalid to retrieve ocean-wave-spectra retrievals from nadir altimeters. Although not valid, a closed-form derivation provides intuitive insights about the information contained in an SAR altimetry cross-spectrum. Under moderate environmental conditions (significant wave heights (SWHs) of ∼2 m), a closed-form solution might still be useful to infer swell-wave spectra from swath-altimetry SAR spectra at incident angles of ∼4°. Comparable to side-looking SAR ocean processing, the cross-spectral analysis for nadir signals reduces noise and might remove the 180° ambiguity of the wave direction. Since the synthetic aperture length of nadir altimeters is larger than sidelooking imaging SARs (e.g., Sentinel-1, RadarSat, Gaofen-3), sublook processing can be performed to compute multiple cross-spectra for the same scene. With a slightly changing observation geometry, the cross-spectra reveal slightly different parts of the ocean-wave spectrum. The resulting stack of cross-spectra can thus be used to improve the retrieval of ocean-wave parameters. Retrieved ocean-wave parameters shall then enhance the sampling of the global wave field, but also serve to advance more consistent sea-state-bias corrections.

@en

Traditionally, nadir-looking satellite radar altimeters provide water surface elevations of rivers only at intersections with the satellite’s ground track, called virtual stations. These observations have limited spatial coverage because such cross-overs are sparse, depending on the altimeter's orbit. In this work, we introduce the novel concept of Polygon-Informed Cross-Track Altimetry (PICTA), enabling precise measurement of water surface elevations at cross-track distances---for as long as the target's signal is recorded in the altimeter's range window. Using fully-focused SAR data from the Sentinel-6 altimetry mission, we demonstrate how the new approach can provide detailed river elevation profiles over a ground swath of about 14 km cross-track width and with an along-track resolution as fine as 10 m. On the one hand, this marks a drastic improvement in the number of available measurements when compared to the virtual station approach, on the other hand, for the first time, water surface slopes and level variations along the river, caused by rapids, dams, and sluices, can be directly observed using a nadir radar altimeter. The validation over two river segments in France reveals biases as low as [[EQUATION]]4 cm and random errors on the order of 3 to 8 cm at 30 m along-track resolution. The new PICTA concept can potentially be generalized to other targets, such as lakes or even coastlines. @en

Estimating the three geophysical variables significant wave height (SWH), sea surface height, and wind speed from satellite altimetry continues to be challenging in the coastal zone because the received radar echoes exhibit significant interference from strongly reflective targets such as sandbanks, sheltered bays, ships etc. Fully focused SAR (FF-SAR) processing exhibits a theoretical along-track resolution of up to less than half a metre. This suggests that the application of FF-SAR altimetry might give potential gains over unfocused SAR (UF-SAR) altimetry to resolve and mitigate small-scale interferers in the along-track direction to improve the accuracy and precision of the geophysical estimates. The objective of this study is to assess the applicability of FF-SAR-processed Sentinel-6 Michael Freilich (S6-MF) coastal altimetry data to obtain SWH estimates as close as possible to the coast. We have developed a multi-mission FF-SAR processor and applied the coastal retracking algorithm CORALv2 to estimate SWH. We assess different FF-SAR and UF-SAR processing configurations, as well as the baseline Level-2 product from EUMETSAT, by comparison with the coastal, high-resolution SWAN-Kuststrook wave model from the Deltares RWsOS North Sea operational forecasting system. This includes the evaluation of the correlation, the median offset, and the percentage of cycles with high correlation as a function of distance to the nearest coastline. Moreover, we analyse the number of valid records and the L2 noise of the records. The case study comprises five coastal crossings of S6-MF that are located along the Dutch coast and the German coast along the East Frisian Islands in the North Sea. We observe that accurate and precise SWH records can be estimated in the nearshore zone within 1–3 km from the coast using satellite SAR altimetry. We find that the FF-SAR-processed dataset with a Level-1b posting rate of 140 Hz shows the greatest similarity with the wave model. We achieve a correlation of ∼0.8 at 80% of valid records and a gain in precision of up to 29% of FF-SAR vs UF-SAR for 1–3 km from the coast. FF-SAR shows, for all cycles, a high correlation of greater than or equal to 0.8 for 1–3 km from the coast. We estimate the decay of SWH from offshore at 30 km to up to 1 km from the coast to amount to 26.4% ± 3.1%.

@en

We demonstrate in this work how we can take advantage of known unfocused SAR (UF-SAR) retracking methods (e.g. the physical SAMOSA model) for retracking of fully-focused SAR (FF-SAR) waveforms. Our insights are an important step towards consistent observations of sea surface height, significant wave height and backscatter coefficient (wind speed) with both UF-SAR and FF-SAR. This is of particular interest for SAR altimetry in the coastal zone, since coastal clutter may be filtered out more efficiently in the high-resolution FF-SAR waveform data, which has the potential to improve data quality. We implemented a multi-mission FF-SAR altimetry processor for Sentinel-3 (S3) and Sentinel-6 Michael Freilich (S6), using a back-projection algorithm, and analysed ocean waveform statistics compared to multilooked UF-SAR. We find for Sentinel-3 that the averaged power waveforms of UF-SAR and FF-SAR over ocean are virtually identical, while for Sentinel-6 the FF-SAR power waveforms better resemble the UF-SAR zero-Doppler beam. We can explain and model the similarities and differences in the data via theoretical considerations of the waveform integrals. These findings suggest to use the existing UF-SAR SAMOSA model for retracking S3 FF-SAR waveforms but the SAMOSA zero-Doppler beam model for S6 FF-SAR waveforms, instead. Testing the outlined approach over short track segments, we obtain range biases between UF-SAR and FF-SAR lower than 2 mm and significant wave height biases lower than 5 cm.

@en