Membrane fouling is still the main obstacle that hinders the development and implementation of anaerobic membrane bioreactor (AnMBR). In conventional upflow anaerobic reactors, sludge at different height usually presents certain differences in characteristics in terms of particle size, etc. The immersion depth of membrane modules in anaerobic reactors can also influence the fouling of membrane. Thus, it is of great interest to investigate the fouling mechanism with the membrane installed at different heights in reactors. The filtration performance and sludge properties were investigated at different heights of AnMBR. The fouling of membrane in the middle position was severer than that in the top and bottom positions. The total resistance of membrane in the top, middle, and bottom positions was 27.31 × 10¹¹ m⁻¹, 34.67 × 10¹¹ m⁻¹, and 25.29 × 10¹¹ m⁻¹, respectively. By comparing the characteristics and structure of bulk sludge and cake layer at three heights, the bulk sludge in the middle position presented higher content of soluble microbial products (SMP) and finer flocs, and the cake layer was also denser. The results obtained in this study indicated that small size of sludge flocs as well as adhesion of SMP might be the major factors governing membrane fouling at different height in the AnMBR.

Sludge morphology considerably affects the mechanism underlying microbial anaerobic degradation of phenol. Here, we assessed the phenol degradation rate, specific methanogenic activity, electron transport activity, coenzyme F₄₂₀ concentration, and microbial community structure of five phenol-degrading sludge of varying particle sizes (i.e., < 20, 20–50, 50–100, 100–200, and > 200 μm). The results indicated an increase in phenol degradation rate and microbial community structure that distinctly correlated with an increase in sludge particle size. Although the sludge with the smallest particle size (< 20 μm) showed the lowest phenol degradation rate (9.3 mg COD·gVSS⁻¹ day⁻¹), its methanogenic activity with propionic acid, butyric acid, and H₂/CO₂ as substrates was the best, and the concentration of coenzyme F₄₂₀ was the highest. The small particle size sludge did not contain abundant syntrophic bacteria or hydrogenotrophic methanogens, but contained abundant acetoclastic methanogens. Moreover, the floc sizes of the different sludge varied in important phenol-degrading bacteria and archaea, which may dominate the synergistic mechanism. This study provides a new perspective on the role of sludge floc size on the anaerobic digestion of phenol.

Anammox process is considered as a promising technology for removing total nitrogen from low-strength ammonium and phenol-containing wastewater. However, it is still a challenge for the anammox process to treat high-strength ammonium and phenol-containing wastewater. A completely separated partial nitritation and anammox (CSPN/A) process was developed to remove total nitrogen from high-strength phenol-containing wastewater. About 92% of COD, 100% of phenol, and 82.4% of total nitrogen were successfully removed at a NH₄ ⁺-N concentration of 200 mg L⁻¹ with a phenol/NH₄ ⁺-N mass ratio of 0.5 in the CSPN/A process. Furthermore, a shock loading of 300 mg phenol L⁻¹ with a phenol/NH₄ ⁺-N mass ratio of 1.5 led to a complete failure of partial nitritation, but the performance was rapidly recovered by the increase of NH₄ ⁺-N concentration. Although the activities of ammonium-oxidizing bacteria and anammox bacteria were severely inhibited at a phenol/NH₄ ⁺-N mass ratio of 1.5, the enrichment of efficient phenol degraders in the CSPN stage could strengthen the performance robustness of partial nitritation and anammox process. Therefore, this study presented a new insight on the feasibility of the anammox process for treating high-strength ammonium and phenol-containing wastewater.

Methyl isobutyl ketone (MIBK) as a solvent is extensively used for the phenols extraction from the wastewater, so it is unavoidable to expose in the effluent due to the solubility and leakage problem. The present study evaluated the impact of MIBK on phenols degradation in an UASB reactor and analyzed its degradation properties. The results indicated that the continuous dosing (0.1 g L⁻¹) and impact (10 g L⁻¹) of MIBK had limited effect on phenols removal (1–2% reduction) in the UASB reactor, but the specific methanogenic activity (SMA) values of sludge decreased by 45–75% after MIBK exposure. Anaerobic degradation rate of MIBK fitted well to a pseudo-first-order kinetic equation with respect to the initial concentration of 35 mg L⁻¹ (k = 0.0115 h⁻¹, R² = 0.9664). Furthermore, the relative methane generation rate constants of MIBK were 0.00816, 0.00613, 0.00273, and 0.00207 d⁻¹ at the initial concentrations of 0.1, 0.5, 5, and 10 g L⁻¹, respectively. MIBK showed higher inhibitory effect on the methanogenesis than on phenols degradation. This study pointed out that the industrial installations should consider the influence of solvent on anaerobic treatment of phenolic wastewater.