This article proposes a novel collaborative-flip synchronized switch harvesting on capacitors (CF-SSHCs) rectifier and multioutput synchronous dc-dc converters with shared capacitors. Compared to the traditional SSHC, our CF-SSHC rectifier can increase the number of flipping phases, potentially enhancing the flipping efficiency and output power under specific conditions where C FLY is close to C_P. The synchronous dc-dc converters reuse the flying capacitors to achieve a high maximum output power improving rate (MOPIR) over a limited input power range and provide multiple outputs. This work achieves an advanced number of flipping phases in capacitor-based rectifier interface technology and explores multiple-input multiple-output configurations, evaluating the system's performance under periodic and shock conditions for the first time. The system's adaptability to various piezoelectric transducer (PT) array configurations is validated, highlighting its potential for Internet of Things (IoT) networks. The design is fabricated in standard 0.18- μ m CMOS. Measurement results demonstrate that the voltage flipping efficiency of up to 83% is achieved. Compared with full-bridge rectifier (FBR), the MOPIR can be increased to 5.06 × and 4.78 × under off-resonance and on-resonance excitation, respectively. It can also achieve a 2.14 × power enhancement under shock excitation. Additionally, when the input power P INFBR is in the range of 1.42-28.4 μ W, the MOPIR of the proposed system is always greater than 4.

@en

This article presents a 10mV-startup-voltage thermoelectric energy harvesting system, assisted by a piezoelectric generator (PEG) as a cold starter. It exploits the fact that when a thermoelectric energy harvesting system is implemented in a place where kinetic energy is also present, the PEG starter can provide a clock signal to start the system. Thanks to the high output impedance of the PEG, the generated clock voltage can easily go over several hundreds of mV, which can be used to drive the boost converter to harvest thermoelectric energy even at an extremely low thermoelectric generator (TEG) voltage. The proposed system was fabricated in a 180-nm BCD process. The measurement results show that the TEG system can start up from the cold state with a TEG voltage as low as 10 mV while maintaining a 63.9% efficiency. The peak power conversion efficiency reaches 83.7% when the TEG voltage is 55 mV.@en