Solar fuels are a promising way to store solar energy seasonally. This paper proposes an earth-abundant heterostructure to split water using a photovoltaic-electrochemical device (PV-EC). The heterostructure is based on a hybrid architecture of a thin-film (TF) silicon tandem on top of a c-Si wafer (W) heterojunction solar cell (a-Si:H (TF)/nc-Si:H (TF)/c-Si(W)) The multijunction approach allows to reach enough photovoltage for water splitting, while maximizing the spectrum utilization. However, this unique approach also poses challenges, including the design of effective tunneling recombination junctions (TRJ) and the light management of the cell. Regarding the TRJs, the solar cell performance is improved by increasing the n-layer doping of the middle cell. The light management can be improved by using hydrogenated indium oxide (IOH) as transparent conductive oxide (TCO). Finally, other light management techniques such as substrate texturing or absorber bandgap engineering were applied to enhance the current density. A correlation was observed between improvements in light management by conventional surface texturing and a reduced nc-Si:H absorber material quality. The final cell developed in this work is a flat structure, using a top absorber layer consisting of a high bandgap a-Si:H. This triple junction cell achieved a PV efficiency of 10.57%, with a fill factor of 0.60, an open-circuit voltage of 2.03 V and a short-circuit current density of 8.65 mA/cm ² . When this cell was connected to an IrO _x /Pt electrolyser, a stable solar-to-hydrogen (STH) efficiency of 8.3% was achieved and maintained for 10 hours.

@en

One of the main problems of renewable energies is storage of the energy carrier. For long-term storage, solar fuels seem to be a good option. Direct solar water splitting could play an important role in the production of these solar fuels. One of the main challenges of this process is the charge separation and collection at the interfaces. The knowledge on photovoltaic (PV) junctions can be used to tackle this challenge. In this work, the use of doped layers to enhance the electric field in an a-SiC:H photocathode, and the use of thin-film silicon multijunction devices to achieve a stand-alone solar water splitting device are discussed. Using a p-i-n structure as a-SiC:H photocathode, a current density of 10mA/cm² is achievable. The p-i-n structure proposed also indicates the suitability of traditional PV structures for solar water splitting. In addition, hybrid devices, including a silicon heterojunction PV device, are proposed. A combination of the a-SiC:H photocathode with a nc-Si:H/c-Si is demonstrated and potential STH efficiencies of 7.9% have been achieved. Furthermore, a purely PV approach such as a triple junction a-Si:H/nc-Si:H/nc-Si:H solar cell is demonstrated, with solar-to-hydrogen (STH) efficiencies of 9.8%

@en

One of the main problems of renewable energies is storage of the energy carrier. For long-term storage, solar fuels seem to be a good option. Direct solar water splitting could play an important role in the production of these solar fuels. One of the main challenges of this process is the charge separation and collection at the interfaces. The knowledge on photovoltaic (PV) junctions can be used to tackle this challenge. In this work, the use of doped layers to enhance the electric field in an a-SiC:H photocathode, and the use of thin-film silicon multijunction devices to achieve a stand-alone solar water splitting device are discussed. Using a p-i-n structure as a-SiC:H photocathode, a current density of 10mA/cm2 is achievable. The p-i-n structure proposed also indicates the suitability of traditional PV structures for solar water splitting. In addition, hybrid devices, including a silicon heterojunction PV device, are proposed. A combination of the a-SiC:H photocathode with a nc-Si:H/c-Si is demonstrated and potential STH efficiencies of 7.9% have been achieved. Furthermore, a purely PV approach such as a triple junction a-Si:H/nc-Si:H/nc-Si:H solar cell is demonstrated, with solar-to-hydrogen (STH) efficiencies of 9.8%.@en