This paper addresses the aspects of image formation and interferometric processing in the frame of the STEREOID Earth Explorer 10 candidate mission. In particular, the large along-track baseline configuration (approx. 250 km), which results in a high Doppler centroid, will be addressed in terms of bistatic SAR image formation and interferometric processing. The proposed focusing algorithm is validated with point-target simulations, while the interferometric investigations are performed using raw data generated with a bistatic end-to-end simulator.

@en

This contribution presents two experiments performed with the TerraSAR-X (TSX) and TanDEM-X (TDX) satellites working in the pursuit monostatic configuration. Their objective is to estimate the along-track component of the motion in the scene in repeat-pass scenarios with an accuracy better than the one given by the stripmap azimuth resolution. Such performance is possible by exploiting the angular diversity of the bidirectional (BiDi) SAR mode and the π-shifted (or staggered) TOPS.

@en

The orbit for Earth observation satellite synthetic aperture radar (SAR) missions is maintained within an Earth-fixed orbital tube to ensure ground-track coverage repeatability and, consequently, to enable repeat-pass interferometric compatibility between data takes. In this letter, it is shown that the size of the orbital tube may affect the interferometric performance in terms of azimuth spectral decorrelation and azimuth coregistration accuracy under the presence of squint. These effects require special consideration for SAR burst modes, such as ScanSAR or TOPS (i.e., Terrain Observation by Progressive Scans). This letter presents and analyzes these aspects in the frame of the Sentinel-1 mission.

@en

This letter addresses the efficient evaluation of Fourier-based kernels for synthetic aperture radar (SAR) image formation. The goal is to evaluate the quality of the focused impulse response function and the residual phase errors of the kernel without having to implement the processor itself nor perform a costly point-target simulation followed by the processing. The proposed methodology is convenient for situations where the assumption of a hyperbolic range history does not hold anymore, and hence, a compact analytic expression of the point target spectrum is not available. Examples where the hyperbolic range history does not apply include very high resolution spaceborne SAR imaging or bistatic SAR imaging. The approach first numerically computes the 2-D spectrum of a point target and then uses the transfer function of the focusing kernel to match it. The spectral support is then computed to adapt the spectrum to the output imaging geometry, so that the impulse response function (IRF) is finally obtained. The proposed approach is valid under the assumption of a large time-bandwidth product, as is usually the case for current air-and spaceborne SAR sensors. The methodology is validated by comparing the matched IRFs with the ones obtained using point-target simulations.@en

This contribution addresses the efficient evaluation of Fourier-based kernels for synthetic aperture radar (SAR) image formation. The goal is to evaluate the quality of the focused impulse response function and the residual phase errors of the kernel without having to implement the processor itself nor perform a costly point-target simulation followed by the processing. The proposed methodology is convenient for situations where the assumption of a hyperbolic range history does not hold anymore, and hence a compact analytic expression of the point target spectrum is not available. Examples where the hyperbolic range history does not apply include very high-resolution spaceborne SAR imaging or bistatic SAR imaging. The approach first computes numerically the two-dimensional (2D) spectrum of a point target and then uses the transfer function of the focusing kernel to match it, and hence obtain the impulse response function (IRF). The methodology is validated by comparing the matched IRFs with the ones obtained using point-target simulations.

@en

This paper reports on several experiments performed with the TerraSAR-X (TSX) and the TanDEM-X (TDX) satellites. The experiments consist in the generation of improved image products by coherently combining the images acquired individually by both satellites, hence the name distributed imaging. In the literature it has already been suggested the use of two or more satellites in close formation not only to have interferometric capabilities, but also to improve the azimuthal or range resolutions by performing the acquisitions simultaneously (no temporal decorrelation). This idea can be carried out by acquiring different portions of the spectrum and adding them coherently afterwards. Another possibility is to synthesize quad-pol acquisitions using dual-pol ones, an idea already carried out with airborne systems. Such experiments have been performed with TSX and TDX and are described in this paper.

@en