No recrystallization of austenite, Tnr, has an important influence on the transformed phase -fractions and the final crystallographic texture after hot deformation. This paper investigates the evolution of microstructure and texture components during hot-rolling in two austenitic region based on Tnr along with three different cooling trajectory and coiling in dual-phase steels and high strength low alloys steel. The recrystallization of the austenite, the austenite deformation followed by the austenite-to-ferrite transformation influence the final microstructure and texture in dual phase steels, have been examined by means of optical microscopy, X-ray diffraction (XRD) measurements. Recrystallized and deformed austenite have clearly different texture components and, due to the specific lattice correspondence relations between the parent austenite phase and its transformation products, the resulting ferrite textures are different as well.@en

Formability had been important property of metals which is attributed to the texture development during thermomechanical processing particularly during hot rolling and cold rolling. In the present paper, the high strength steels with different carbon and manganese composition have been hot rolled above and below of austenite recrystallization temperature and followed by fast cooling up to different coiling temperature to get hot bands with different texture and two phase microstructure consisting ferrite with pearlite, bainite and martensite. Subsequently, these hot bands were cold rolled with 80 percent under plain strain condition. The microstructure of cold rolled sheets samples were analyzed using scanning electron microscope and showed the cold rolled microstructure with strong pancaked of two phase which was carried from the hot rolling. Cold rolled texture in ferrite pearlite microstructure is completely replaced by new texture components from hot rolled condition without the effect of Tnr. Hot rolled texture was retained in ferrite-bainite and martensite microstructure with the effect of Tnr. Increase in alloy chemistry weakens the texture intensity in ferrite pearlite/bainite microstructure. Whereas increase in alloy chemistry strengthens the texture intensity in ferrite martensite microstructure. @en