In the region close to the thermodynamic critical point and in the proximity of the pseudoboiling (Widom) line, strong property variations substantially alter the growth of modal instabilities, as revealed in Ren et al. [J. Fluid Mech. 871, 831 (2019)0022-112010.1017/jfm.2019.348]. Here, we study nonmodal disturbances in the spatial framework using an eigenvector decomposition of the linearized Navier-Stokes equations under the assumption of locally parallel flow. To account for nonideality, a new energy norm is derived. Several heat transfer scenarios at supercritical pressure are investigated, which are of practical relevance in technical applications. The boundary layers with the fluid at supercritical pressure are heated or cooled by prescribing the wall and free-stream temperatures so that the temperature profile is either entirely subcritical (liquidlike), supercritical (gaslike), or transcritical (across the Widom line). The free-stream Mach number is set to 10-3. In the nontranscritical regimes, the resulting streamwise-independent streaks originate from the lift-up effect. Wall cooling enhances the energy amplification for both subcritical and supercritical regimes. When the temperature profile is increased beyond the Widom line, a strong suboptimal growth is observed over very short streamwise distances due to the Orr mechanism. Due to the additional presence of transcritical Mode II, the optimal energy growth at large distances is found to arise from an interplay between lift-up and Orr mechanism. As a result, optimal disturbances are streamwise-modulated streaks with strong thermal components and with a propagation angle inversely proportional to the local Reynolds number. The nonmodal growth is put in perspective with modal growth by means of an N-factor comparison. In the nontranscritical regimes, modal stability dominates regardless of a wall-temperature variation. In contrast, in the transcritical regime, nonmodal N factors are found to resemble the imposition of an adverse pressure gradient in the ideal-gas regime. When cooling beyond the Widom line, optimal growth is greatly enhanced, yet strong inviscid instability prevails. When heating beyond the Widom line, optimal growth could be sufficiently large to favor transition, particularly with a high free-stream turbulence level.

Control of laminar-to-turbulent transition on a swept-wing is achieved by base-flow modification in an experimental framework, up to a chord Reynolds number of 2.5 million. This technique is based on the control strategy used in the numerical simulation by Dörr & Kloker (J. Phys. D: Appl. Phys., vol. 48, 2015b, 285205). A spanwise uniform body force is introduced using dielectric barrier discharge plasma actuators, to either force against or along the local cross-flow component of the boundary layer. The effect of forcing on the stability of the boundary layer is analysed using a simplified model proposed by Serpieri et al. (J. Fluid Mech., vol. 833, 2017, pp. 164–205). A minimal thickness plasma actuator is fabricated using spray-on techniques and positioned near the leading edge of the swept-wing, while infrared thermography is used to detect and quantify transition location. Results from both the simplified model and experiment indicate that forcing along the local cross-flow component promotes transition while forcing against successfully delays transition. This is the first experimental demonstration of swept-wing transition delay via base-flow modification using plasma actuators.