Shear wave elastography (SWE) has the potential to determine cardiac tissue stiffness from non-invasive shear wave speed measurements, important, e.g., for predicting heart failure. Previous studies showed that waves traveling in the interventricular septum (IVS) may display Lamb-like dispersive behaviour, introducing a thickness-frequency dependency in the wave speed. However, the IVS tapers across its length, which complicates wave speed estimation by introducing an additional variable to account for. The goal of this work is to assess the impact of tapering thickness on SWE. The investigation is performed by combining in vitro experiments with acoustic radiation force (ARF) and 2D finite element simulations, to isolate the effect of the tapering curve on ARF-induced and natural waves in the heart. The experiments show a 11% deceleration during propagation from the thick to the thin end of an IVS-mimicking tapered phantom plate. The numerical analysis shows that neglecting the thickness variation in the wavenumber-frequency domain can introduce errors of more than 30% in the estimation of the shear modulus, and that the exact tapering curve, rather than the overall thickness reduction, determines the dispersive behaviour of the wave. These results suggest that septal geometry should be accounted for when deriving cardiac stiffness with SWE.

@en

Natural and active shear wave elastography (SWE) are potential ultrasound-based techniques to non-invasively assess myocardial stiffness, which could improve current diagnosis of heart failure. This study aims to bridge the knowledge gap between both techniques and discuss their respective impacts on cardiac stiffness evaluation. We recorded the mechanical waves occurring after aortic and mitral valve closure (AVC, MVC) and those induced by acoustic radiation force throughout the cardiac cycle in four pigs after sternotomy. Natural SWE showed a higher feasibility than active SWE, which is an advantage for clinical application. Median propagation speeds of 2.5–4.0 m/s and 1.6–4.0 m/s were obtained after AVC and MVC, whereas ARF-based median speeds of 0.9–1.2 m/s and 2.1–3.8 m/s were reported for diastole and systole, respectively. The different wave characteristics in both methods, such as the frequency content, complicate the direct comparison of waves. Nevertheless, a good match was found in propagation speeds between natural and active SWE at the moment of valve closure, and the natural waves showed higher propagation speeds than in diastole. Furthermore, the results demonstrated that the natural waves occur in between diastole and systole identified with active SWE, and thus represent a myocardial stiffness in between relaxation and contraction.

@en

Shear Wave Elastography (SWE) has been proposed to investigate cardiac health by non-invasively monitoring tissue stiffness. Previous work has shown that the plate-like geometry of the Interventricular Septum (IVS) may result in a dispersion similar to Lamb waves, complicating the link between shear wave speed and cardiac stiffness. However, the IVS is not a simple plate, e.g., its thickness tapers across its length. We have used 2-D Finite Element simulations to investigate the effects of tapering on Lamb waves. The model consists of an elastic slab immersed in water, with a thickness decreasing smoothly in space from 9 to 3 mm. Pulses with low (0-80 Hz) and high (0-700 Hz) frequency contents were used to excite natural and acoustic radiation force induced waves. The results show that natural waves can decelerate by up to 20% during propagation, leading to ambiguities in speed estimation. Moreover, neglecting tapering when fitting their dispersion curves can introduce errors in shear modulus estimation by up to 30%. In contrast, fits performed on waves with high frequency content yielded shear modulus estimations with < 5%. These results suggest that septal geometry can affect cardiac stiffness estimation performed by SWE, especially when natural waves are employed.

@en

Shear Wave Elastography (SWE) has been proposed to investigate cardiac health by non-invasively monitoring tissue stiffness. Previous work has shown that the plate-like geometry of the Interventricular Septum (IVS) may result in a dispersion similar to Lamb waves, complicating the link between shear wave speed and cardiac stiffness. However, the IVS is not a simple plate, e.g., its thickness tapers across its length. We have used 2-D Finite Element simulations to investigate the effects of tapering on Lamb waves. The model consists of an elastic slab immersed in water, with a thickness decreasing smoothly in space from 9 to 3 mm. Pulses with low (0–80 Hz) and high (0–700 Hz) frequency contents were used to excite natural and acoustic radiation force induced waves. The results show that, at the lower frequencies, propagation speed can decrease during propagation by ~20% due to the thickness reduction, producing a nonlinear space-time relation from which multiple speed values can be extracted. At higher frequencies, the main observation is a dependence of the dispersion behavior on the shape of the tapering (e.g., linear, concave, or convex). These results suggest that septal geometry is likely to play a role in deriving cardiac stiffness from propagation speed measurements.@en

Different shear wave elastography methods have been proposed to measure cardiac material properties. This study compared shear waves naturally generated by aortic and mitral valve closure to those externally induced with an acoustic radiation force throughout the cardiac cycle. The shear wave timing and propagation speeds were measured in four pigs with open-chest recordings. Despite spatial and temporal differences in excitation source, the propagation speeds of the natural shear waves were found to be in the same range as the propagation speeds of the active shear waves. The results also suggested a large inter-beat variability for the natural shear waves.

@en