Spider silk is known for its excellent strength and fracture resistance properties due to its molecular design structure, characterized by sacrificial bonds and hidden lengths. These structures have inspired reinforcements of synthetic polymer materials to enhance toughness. In this study, we mimic these natural toughening mechanisms by designing and manufacturing 3D-printed polymeric structures incorporating overlapping curls consisting of coiling fiber with sacrificial bonds and hidden lengths. Utilizing the liquid rope coiling effect, we manufactured overlapping curls using three polymers: polylactic acid (PLA), liquid crystal polymer (LCP), and polyamide 6 (PA6). Uniaxial tensile tests were performed to characterize the mechanical properties of overlapping curl as a function of geometries, post-treatments, and material constitutive parameters. Our results show that single-sided overlapping curls can fully unfold while double-sided curls are prone to premature failure. Heat-pressure post-treatment was found to significantly increase the load-capacity of the sacrificial bonds by up to [Formula presented] due to increased contact area. However, the defects introduced in the fibre after the break of the sacrificial bonds, make the structure more susceptible to premature failure, limit the complete unfolding of the hidden length, and lead to a decrease up to [Formula presented] of the toughness. To guarantee the complete unfolding of the hidden lengths and improve the toughness, we demonstrate that selecting a polymer material with either high fracture strength (e.g., LCP, [Formula presented]) or high fracture strain (e.g., PA6, >2) is crucial, and increase toughness up to [Formula presented] and [Formula presented], respectively.

@en

Bio-based epoxy materials face major challenges in their relatively poor mechanical properties compared to their petroleum-based competitors, including low fracture toughness and abrupt failure. By mimicking the molecular structure of spider silk, which is one of the toughest materials in nature, we manufactured polymer overlapping curls consisting of coiling fibers with sacrificial bonds and hidden lengths through 3D printing. These curls were embedded in a bio-based epoxy aiming to improve its toughness. The bio-based epoxy adhesive layer integrated by such 3D-printed coiling fibers was tested under mode I opening load using Double Cantilever Beam tests. The results show an extrinsic bridging triggered by the embedded curls that promote progressive failure and improve the mode I fracture toughness by 285%. The proposed 3D-printed coiling fibers can improve the performance of biobased epoxies and retard crack growth, opening new horizons for their use in structural applications and the use of these bio-inspired overlapping curls to control crack growth in adhesively bonded joints. @en

Aiming to aid the sustainable transition to fossil fuel-free epoxy materials and enhance the toughness of bio-based epoxies, here we integrate an overlapping curl microstructure consisting of coiling fiber with sacrificial bonds and hidden lengths into a bio-based epoxy matrix. Inspired by natural material, where exceptional properties are achieved at low environmental cost, the microstructure mimics the molecular structures of spider silk, known for its exceptional fracture resistance. The 3D-printed overlapping curl shows a saw-tooth mechanical response with continuous load-carrying ability thanks to the break of sacrificial bonds and unfolding of the hidden lengths. By embedding the overlapping curl into the compact-tension configuration of the bio-based epoxy, an extrinsic toughening mechanism is triggered as the hidden length unfolds. Experimental results show that a single-sided overlapping curl structure is able to improve the toughness of bio-based epoxy by 19%.@en