In situ soil moisture monitoring networks are critical to the development of soil moisture remote sensing missions as well as agricultural and environmental management, weather forecasting, and many other endeavors. These in situ networks utilize a variety of sensors and installation practices, which confounds the development of a unified reference database for satellite calibration and validation programs. As part of the Soil Moisture Active Passive Mission, the Marena, Oklahoma, In Situ Sensor Testbed (SMAP-MOISST) was initiated to perform inter-comparisons and study sensor limitations. Soil moisture sensors that are deployed in major monitoring networks were included in the study, along with new and emerging technologies, such as the Cosmic Ray Soil Moisture Observing System (COSMOS), passive/active distributed temperature sensing (DTS), and global positioning system reflectometers (GPSR). Four profile stations were installed in May of 2010, and soil moisture was monitored to a depth of 1 m on an hourly basis. The four stations were distributed within a circular domain of approximately 600 m diameter, adequate to encompass the sensing range of COSMOS. The sensors included in the base station configuration included the Stevens Water Hydra Probe, Campbell Scientific 616 and 229, Decagon EC-TM, Delta-T Theta Probe, Acclima, and Sentek EnviroSMART capacitance system. In addition, the Pico TRIME system and additional time-domain reflectometry (TDR) systems were deployed when available. It was necessary to apply site-specific calibration to most sensors to reach an RMSE below 0.04 m³ m^-3. For most sensor types, a single near surface sensor could be scaled to represent the areal-average of a field domain by simple linear regression, resulting in RMSE values around 0.03 m³ m^-3.

This study demonstrated a new method for mapping high-resolution (spatial: 1 m, and temporal: 1 h) soil moisture by assimilating distributed temperature sensing (DTS) observed soil temperatures at intermediate scales. In order to provide robust soil moisture and property estimates, we first proposed an adaptive particle batch smoother algorithm (APBS). In the APBS, a tuning factor, which can avoid severe particle weight degeneration, is automatically determined by maximizing the reliability of the soil temperature estimates of each batch window. A multiple truth synthetic test was used to demonstrate the APBS can robustly estimate soil moisture and properties using observed soil temperatures at two shallow depths. The APBS algorithm was then applied to DTS data along a 71 m transect, yielding an hourly soil moisture map with meter resolution. Results show the APBS can draw the prior guessed soil hydraulic and thermal properties significantly closer to the field measured reference values. The improved soil properties in turn remove the soil moisture biases between the prior guessed and reference soil moisture, which was particularly noticeable at depth above 20 cm. This high-resolution soil moisture map demonstrates the potential of characterizing soil moisture temporal and spatial variability and reflects patterns consistent with previous studies conducted using intensive point scale soil moisture samples. The intermediate scale high spatial resolution soil moisture information derived from the DTS may facilitate remote sensing soil moisture product calibration and validation. In addition, the APBS algorithm proposed in this study would also be applicable to general hydrological data assimilation problems for robust model state and parameter estimation.