4th generation district heating and cooling networks (shortly THERNETs) are often coined as a crucial technology to enable the transition towards low-carbon smart energy systems. Most importantly, they open perspectives for integration of low-grade residual heat from industry, renewable energy sources (such as geothermal heat and cold and solar thermal collectors), more efficient energy conversion units (such as collective heat pumps), while thermal energy storage (TES) systems increase system flexibility. In order to optimize design and control of such complex systems, a toolbox modesto (Multi-objective district energy systems toolbox for optimization) is under development. However, the representation of seasonal heat and cold storage systems on an annual basis requires large computational power. In an attempt to decrease computational cost, a technique with representative time slices (inspired by and combining aspects from optimization studies of electrical energy systems, unit commitment problems, thermal systems with short term energy storage and smaller scale industrial thermal systems with longer term energy storage) is developed and tested. The aim of this study is to investigate the applicability of such representative time periods to optimize seasonal TES systems in THERNETs. To this end a full year optimization is compared to one with representative time periods for a realistic case study that uses demand profiles from the city of Genk (Belgium) and energy system parameters from Marstal (Denmark). This comparative study shows that modelling with representative periods is sufficient to mimic the behaviour of a full year optimization. However, when curtailment of solar heat injection occurs, not all representations yield the same results. It was found that for the studied case, a selection of 12 representative weeks performs best, while all reduced optimizations result in a substantial reduction (speed-up of on average x4.8 to x7.7) of the calculation time.@en

Bypass valves in district heating substations are a compromise between efficiency and quality of service. On the one hand, they are required to ensure that each building (no matter the distance to the heat source) has warm water within an acceptable time. On the other hand, they form a short-circuit between the warm supply and cold return line and their use can increase the return temperature substantially. Therefore, a good control of these bypass valves is critical to limit the drawback of their use. In this context, this paper compares two commonly used control strategies (manual control and thermostat control) to a new theoretical benchmark that provides an upper boundary for the performance of bypass controllers. This theoretical benchmark ensures a just-in-time delivery of warm water by taking into account time delays in the network. In a simulation case study of a small neighbourhood in Genk, Belgium, the benchmark shows that substantial improvement regarding bypass control is possible.

@en