The aim of this study was to investigate the applicability of acoustic emission (AE) technique to evaluate delamination crack in glass/epoxy composite laminates under quasi-static and fatigue loading. To this aim, double cantilever beam specimens were subjected to mode I quasi-static and fatigue loading conditions and the generated AE signals were recorded during the tests. By analyzing the mechanical and AE results, an analytical correlation between the AE energy with the released strain energy and the crack growth was established. It was found that there is a 3rd degree polynomial correlation between the crack growth and the cumulative AE energy. Using this correlation the delamination crack growth was predicted under both the static and fatigue loading conditions. The predicted crack growth values was were in a good agreement with the visually recorded data during the tests. The results indicated that the proposed AE-based method has good applicability to evaluate the delamination crack growth under quasi-static and fatigue loading conditions, especially when the crack is embedded within the structure and could not be seen visually.@en

Currently, onshore wind turbines are economical for 2.5 mega-watt inland installation [1]. One of the alternatives to achieve the higher power capacity in onshore wind turbines is to go to higher altitude, which increases the wind speed and has more uniform wind pressure, leading to higher possible annual energy production and relatively lower maintenance costs due to wind shear induced vibrations. This paper deals with a predesign of a new type of tower that should overcome known disadvantages of steel tubular towers for heights over 150 meters. This first part of the paper addresses the viability of a hybrid support structure in respect of ultimate limit states and structural dynamics as part of the requirements in exploring the feasibility of the hybrid tower concept. The hybrid wind turbine tower concept consists of a lattice (lower) structure and a tubular tower for the higher tower segment. The study cases found in literature were designed with maximum height of 160m and the 2.5MW wind turbine. Moreover, they used commercial "L" sections which leads to high number of connections and bolts. The project that supports the present paper aims at using optimally design hollow cross sections, to reduce the number of connections, and low maintenance type bolts. The developed study case is made for 220m tower height and using 5MW wind turbine.

@en