The Boom Clay is a potential host rock for geological storage of radioactive waste in the Netherlands and Belgium. The redox properties of the host rock are important in the context of safety assessment as they affect the speciation and thus the mobility of redox sensitive radionuclides. In this study, redox properties of the clay were assessed by mediated electrochemical analyses. The electron donating (EDC) and accepting (EAC) capacities and reduction potential of a suite of Boom Clay samples were determined. Boom Clay samples from various locations in the Netherlands and Belgium were investigated in unaltered form, and after size separation or chemical treatment to relate variations in redox properties to regional differences in diagenetic history or in the assemblage of allogenic minerals. In the investigated samples, the EDC can be attributed to the oxidation of pyrite, Fe^II in clay minerals and reduced natural organic matter (NOM) while the EAC can be ascribed to the reduction of Fe^III in clay minerals and in Fe (oxyhydr)oxides. Combining Na-pyrophosphate extraction, to remove reactive NOM, with mediated electrochemical oxidation (MEO) allowed determining the individual EDC of NOM and Fe^II in clay minerals. Mediated electrochemical analysis showed systematic differences between samples from two locations in the Netherlands, Zeeland and Limburg. In samples from Zeeland, the reduction potential was higher, the EAC was larger, and the contribution of NOM to the EDC was smaller compared to samples from Limburg. These differences can be attributed to partial oxidation of Boom Clay in Zeeland during its diagenetic history but partial oxidation could also be a storage artefact. The electron yield obtained by pyrite oxidation in samples from Zeeland was larger compared to those from Limburg, which can be explained by a smaller particle size of pyrite in Zeeland. The size of pyrite particles, in turn, can be used as a proxy for the depositional conditions. The electrochemical activity of Fe in clay minerals did not vary systematically between the two locations in the Netherlands. In general, the fraction of electrochemically active Fe in clay minerals increased with the relative content of 2:1 clay minerals. In comparison with samples from the Netherlands, larger fractions of structural Fe in clay minerals were redox-active in samples from Belgium, which had a higher chlorite or glauconite content. This study demonstrates that mediated electrochemical analysis can reveal redox properties of Boom Clay, which might be of relevance for the migration of redox sensitive radionuclides or when assessing the impact of constructing and operating a repository for nuclear waste on the surrounding host rock.

Iron-electrocoagulation is a promising contaminant (e.g. arsenic) removal technology that is based on electrochemical Fe(II) production from steel electrodes and subsequent transport of Fe(II) to the bulk solution, where contaminant removal occurs. Although Fe-electrocoagulation systems have been shown to effectively remove contaminants in extended field trials, the efficiency of field systems can be lower than in laboratory studies. One hypothesis for this disparity is that the Faradaic efficiency of short-term laboratory experiments is higher than field systems operated over extended periods. The Faradaic efficiency is a pivotal performance indicator that we define as the measured Fe dosage normalized by the theoretical Fe dosage calculated by Faraday's law. In this work, we investigated the Faradaic efficiency in laboratory experiments for up to 35 operating cycles (>2 months) with varied Fe(0) anode purity, charge dosage rate, and electrolyte composition. Our results showed that the Faradaic efficiency decreased continuously during repeated operation under typical field conditions (charge dosage rate = 4 C/L/min, synthetic groundwater) regardless of the Fe(0) anode purity, leading to a Faradaic efficiency ≈ 0.6 after 2 months. By contrast, increasing the charge dosage rate to ≥15 C/L/min produced a Faradaic efficiency >0.85 over the entire experiment for both Fe(0) anode purities. Electrolyte solutions free of oxyanions also resulted in sustained Faradaic efficiency >0.85, regardless of the charge dosage rate. Our results confirm a previously proposed relationship between low Faradaic efficiency and the formation of macroscopic electrode surface layers, which consist of Fe (oxyhydr)oxides on the anode and a mixture of Fe (oxyhydr)oxides and calcite on the cathode. Based on these results, we discuss potential strategies to maintain a high Faradaic efficiency during Fe-electrocoagulation field treatment.