Currently, photovoltaic (PV) installations target a maximization of annual energy yield. However, as the grid penetration of PV is increasing, PV electricity generation will need to match better with local load profiles. Especially the seasonal variabilities remain challenging. While wind and PV tend to have complementary seasonal variability, wind turbine installation faces limitations especially in densely populated areas. In this paper, we discuss how this challenge may be addressed with climate- and consumption-specific PV module technology. In particular, we demonstrate how the temperature coefficient of a PV system can impact the energy yield throughout the year. In colder climates, higher temperature coefficients allow for a better energy balance, favoring production in colder seasons without a significant reduction of yearly energy yield. Simulations for locations at high latitude, and colder climates, indicate that higher temperature coefficients and improved low-light behavior not only enable a higher energy yield in cold seasons, but also negligible losses in the overall yearly energy yield compared to lower temperature coefficients and slightly better low-light behavior. Simulations show that these results can be obtained using commercial PV modules. More broadly, they indicate how PV module technology may be optimized depending on the location and climate.

Façade building-integrated photovoltaics is a technology that transforms a passive façade into a distributed, renewable electrical generator by the inclusion of solar cells in the building envelope. Partial shading due to nearby objects is a typical problem for façade building-integrated photovoltaics as it strongly reduces the output power of the installation. Distributed maximum power point tracking by means of embedded converters and a common direct current bus has been proposed to alleviate this issue. However, the bus voltage plays an important role in converter topology selection and overall efficiency, although this is not being covered in literature. Also the influence of the solar cell technology on the output voltage of the module is not studied before, although it strongly influences the converter topology selection and the losses. In this paper, a methodology is described to investigate the influence of the voltage level and solar cell technology by taking conversion losses in the converters and the cabling into account. The methodology is applied to two case study buildings for which four different cell technologies are considered. It is shown that overall high efficiencies are obtained, regardless of the voltage level. However, the loss distribution changes significantly with the voltage. This aspect can be used advantageously to reduce thermal stresses on the embedded converter. Furthermore, the overall system efficiency is typically higher when the voltage step-up is lower.