The adaptive control of sunlight through photochromic smart windows could have a huge impact on the energy efficiency and daylight comfort in buildings. However, the fabrication of inorganic nanoparticle and polymer composite photochromic films with a high contrast ratio and high transparency/low haze remains a challenge. Here, a solution method is presented for the in situ growth of copper-doped tungsten trioxide nanoparticles in polymethyl methacrylate, which allows a low-cost preparation of photochromic films with a high luminous transparency (luminous transmittance T_lum = 91%) and scalability (30 × 350 cm²). High modulation of visible light (ΔT_lum = 73%) and solar heat (modulation of solar transmittance ΔT_sol = 73%, modulation of solar heat gain coefficient ΔSHGC = 0.5) of the film improves the indoor daylight comfort and energy efficiency. Simulation results show that low-e windows with the photochromic film applied can greatly enhance the energy efficiency and daylight comfort. This photochromic film presents an attractive strategy for achieving more energy-efficient buildings and carbon neutrality to combat global climate change.

@en

Photochromic smart windows have drawn increasing attention as an approach to improve building energy efficiency and enhance indoor daylight comfort. However, existing photochromic smart windows still block sunlight from entering the room on sunny winter days, causing additional energy consumption for heating. Herein, a dual-mode smart window is designed with decoupled photo and thermal functions by combining colorless Fe-doped WO3 photochromic film with window rotation. Based on this, selective heating and cooling of the room between winter and summer is achieved while maintaining the daylight comfort benefits during all seasons. As a proof of concept, the smart window reduces the temperature of a model house by up to 7.9 °C in summer mode, while in winter mode the temperature is only reduced by 0.7 °C. The proposed seasonally adaptive dual-mode smart window obtains by window rotation overcomes the limitations of conventional photochromic smart windows, which not only achieves better energy efficiency but also retains improved daylight comfort. Furthermore, it demonstrates that the heat absorbed by the smart window can be harnessed to produce electricity through the integration of thermoelectric modules within the glazing, which enhances its impact on reducing energy consumption.@en

Accurately controlling light emission using nano- and microstructured lenses and antennas is an active field of research. Dielectrics are especially attractive lens materials due to their low optical losses over a broad bandwidth. In this work we measure highly directional light emission from patterned quantum dots (QDs) aligned underneath all-dielectric nanostructured microlenses. The lenses are designed with an evolutionary algorithm and have a theoretical directivity of 160. The fabricated structures demonstrate an experimental full directivity of 61 ± 3, three times higher than what has been estimated before, with a beaming half-angle of 2.6°. This high value compared to previous works is achieved via three mechanisms. First, direct electron beam patterning of QD emitters and alignment markers allowed for more localized emission and better emitter-lens alignment. Second, the lens fabrication was refined to minimize distortions between the designed shape and the final structure. Finally, a new measurement technique was developed that combines integrating sphere microscopy with Fourier microscopy. This enables complete directivity measurements, contrary to other reported values, which are typically only partial directivities or estimates of the full directivity that rely partly on simulations. The experimentally measured values of the complete directivity were higher than predicted by combining simulations with partial directivity measurements. High directivity was obtained from three different materials (cadmium-selenide-based QDs and two lead halide perovskite materials), emitting at 520, 620, and 700 nm, by scaling the lens size according to the emission wavelength.

@en