Haptic guidance is a promising method for assisting an operator in solving robotic remote operation tasks. It can be implemented through different methods, such as virtual fixtures, where a predefined trajectory is used to generate guidance forces, or interactive guidance, where sensor measurements are used to assist the operator in real-time. During the last years, the use of learning from demonstration (LfD) has been proposed to perform interactive guidance based on simple tasks that are usually composed of a single stage. However, it would be desirable to improve this approach to solve complex tasks composed of several stages or gestures. This paper extends the LfD approach for object telemanipulation where the task to be solved is divided into a set of gestures that need to be detected. Thus, each gesture is previously trained and encoded within a Gaussian mixture model using LfD, and stored in a gesture library. During telemanipulation, depending on the sensory information, the gesture that is being carried out is recognized using the same LfD trained model for haptic guidance. The method was experimentally verified in a teleoperated peg-in-hole insertion task. A KUKA LWR4+ lightweight robot was remotely controlled with a Sigma.7 haptic device with LfD-based shared control. Finally, a comparison was carried out to evaluate the performance of Gaussian mixture models with a well-established gesture recognition method, continuous hidden Markov models, for the same task. Results show that the Gaussian mixture models (GMM)-based method slightly improves the success rate, with lower training and recognition processing times.

@en

This paper introduces a new Learning from Demonstration (LfD)-based method that makes usage of robot effector forces and torques recorded during expert demonstrations, to generate force-based haptic guidance reference trajectories on-line, that are intended to be used during haptic shared control for additional operator 'guidance'. Derived haptic guidance trajectories are superimposed to master-device inputs and feedback forces within a bilateral control experiment, to assist an operator by the guidance during peg-in-hole insertion. We show that 96 peg-in-hole expert demonstrations were sufficient to obtain a good model of the task, which was used on-line to generate haptic guidance trajectories in real-time with a 1kHz sampling rate.

@en

Learning from Demonstration has been successfully used in robotics for trajectory generation. However, this methodology has not been used to solve generic tasks by haptic guidance in teleoperation yet. Therefore, the aim of this paper is to solve the peg-in-hole insertion task using Learning from Demonstration, guiding the operator during the execution of this task in haptic teleoperation.@en