This study presents the first evaluation of using commercial microwave link (CML) data for rainfall measurements in Australia, with the test site being the greater Melbourne Metropolitan area. More than 100 CMLs with microwave frequency ranging between 10 and 40 GHz have been used for the rainfall retrieval. The 15-minute received signal levels (RSLs) for each CML based on two sampling strategies (average and minimum/maximum) collected for 2 years provided a unique dataset to compare performances of rainfall retrievals. The open source algorithm RAINLINK was used for deriving rainfall from the 15-minute RSL data. From two years of data, a subset of 30 rainy days distributed across this period were used for calibrating the RAINLINK parameters, with the remaining data used for validation. For this study, only path-averaged rainfall intensities were validated based on a gauge-adjusted radar product serving as the reference. The result of the wet-dry classification showed that the minimum and maximum RSL data performed better, with lower probability of false detection and higher Matthews correlation coefficient than average RSL data. For the rainfall retrieval, both datasets showed similar correlation with the gauge adjusted radar product. However, based on other statistics (RMSE, bias and CV) minimum and maximum RSL data outperformed average for the rainfall retrieval. Overall, this study highlights the robust accuracy of commercial microwave links for rainfall retrieval while using only minimum and maximum RSL data.

Commercial microwave links (CMLs) have proven useful for providing rainfall information close to the ground surface. However, large uncertainties are associated with these retrievals, partly due to challenges in the type of data collection and processing. In particular, the most common case is when only minimum and maximum received signal levels (RSLs) over a given time interval (hereafter 15 min) are stored by mobile network operators. The average attenuation and the corresponding rainfall rate are then calculated based on a weighted average method using the minimum and maximum attenuation. In this study, an alternative to using a constant weighted average method is explored, based on a machine learning model trained to produce actual attenuation from minimum/maximum values. A rainfall retrieval deep learning model was designed based on a long short-term memory (LSTM) model architecture and trained with disdrometer data in a form that is comparable to the data provided by mobile network operators. A first evaluation used only disdrometer data to mimic both attenuation from a CML and corresponding rainfall rates. For the test data set, the relative bias was reduced from 5.99% to 2.84% and the coefficient of determination (R²) increased from 0.86 to 0.97. The second evaluation used this disdrometer-trained LSTM to retrieve rainfall rates from an actual CML located nearby the disdrometer. A significant improvement in the overall rainfall estimation compared to existing microwave link attenuation models was observed. The relative bias reduced from 7.39% to −1.14% and the R² improved from 0.71 to 0.82.