The Gran Sasso carbonate aquifer is the largest and most productive in the Apennines. Its hydrogeological structure has been studied since the middle of the last century for the springs’ characterization for drinking purposes and for a motorway tunnel. Meanwhile, its hydrodynamic parametrization is less developed and has been limited to monitoring the discharge and chemical and isotopic parameters. Secondary porosity characterizes the aquifer, and an underlying impermeable marly complex represents the basal aquiclude. It might appear inappropriate to characterize the hydraulic properties via pumping tests, as their reliability has been proven in homogeneous and isotropic media. However, the high extent of the aquifer, the wells’ location, the scarcity of information available and the lack of alternatives has forced the estimation of hydrodynamic parameters as in porous aquifers and the experimental testing of the aquifer, especially in maximum pumping conditions, for a possible exploitation increase. Since aquifer testing was performed during the normal well field’s activities, it was not possible to perform typical tests. Therefore, the step-drawdown test was conducted by turning on an increasing number of wells over time and keeping the observation points fixed. As results, a mean hydraulic conductivity of 5 × 10−3 m/s and a mean transmissivity of 0.3 m2/s were established without interrupting the water supply; meanwhile, the influence radius and flow directions were also estimated.@en

Recently, new numerical methods have been applied to weather data for the estimation of water budget, especially when the lack of measured data is considerable. Geostatistics is one of the most powerful approaches when it comes to studying spatially relevant natural phenomena, as it considers the spatial correlation among measurements over a specific study area and provides the associate uncertainty. In this study, we tested the feasibility of using a geostatistical method to provide a reliable estimation of the water budget of the Foro river basin (Central Italy) by comparing the obtained results with those of a traditional yet robust method. The results obtained with the geostatistical approach proved to be in line with the ones from the traditional method. Additionally, it was possible to quantify the uncertainty associated with the discharge values, making the estimates more reliable than the ones obtained with the traditional approach. However, the yearly distribution of river discharge obtained using both methods appeared to be dissimilar to the measured ones. The surface water uses, as well as the regulatory effect of the carbonate and alluvial aquifer regime, may affect the river discharge variability over the year and then can account for similar discrepancies between the inflow and outflow water volumes.@en

Rain gauge spatial sparsity and temporal discontinuity of data represent one of the major issues for reliable recharge estimations. In the past decades, the use of ground-based microwave weather RaDAR has dramatically improved quantitative rainfall estimation by providing spatially continuous estimates of rainfall over an area of more than 400 km² every 10 minutes. Furthermore, weather RaDAR data have also proved relatively reliable in mountainous areas. These paramount features of RaDAR-derived precipitation data could improve the estimation of potential recharge of aquifers, which rely on geospatializations (e.g., Thiessen polygons) of rainfall data collected by a sparse rain gauge network which often shows lacking at high altitude (i.e., recharge areas), introducing additional uncertainty in the inflow volumes. Weather RaDAR rainfall estimation is also affected by various sources of error, which can be reduced by proper post-processing; however, uncertainties remain, especially for surface rain rate estimations. Despite the currently necessary complex numerical processing, the purpose of the study is to evaluate the use of the weather RaDAR data as an alternative or in addition to meteorological data. Based on the above considerations, the feasibility of using RaDAR-based precipitation data to estimate aquifer potential recharge and calculate a detailed water budget in the areas characterized by high elevations, such as the Majella massif in the central Apennines, has been evaluated. To address this objective, the water budget has been calculated in the 2017-2018 period using both RaDAR-based precipitation data and rain gauge data, as well as adopting different methods (i.e., Turc and Thornthwaite). Although intrinsically uncertain, the RaDAR-based precipitation data provided solid results, pointed out by comparing it with water budget obtained by rain gauge data, and especially with experimental literature data. This interdisciplinary work may pave the way for continuous monitoring of aquifer potential recharge at extremely high temporal and spatial resolution.

@en

Accurate knowledge of the rain amount is a crucial driver in several hydrometeorological applications. This is especially true in complex orography territories, which are typically impervious, thus, leaving most mountain areas ungauged. Due to their spatial and temporal coverage, weather radars can potentially overcome such an issue. However, weather radar, if not accurately processed, can suffer from several limitations (e.g., beam blocking, altitude of the observation, path attenuation, and indirectness of the measurement) that can hamper the reliability of the rain estimates performed. In this study, a comparison between rain gauge and weather radar retrievals is performed in the target area of the Abruzzo region in Italy, which is characterized by a heterogeneous orography ranging from the seaside to Apennine ridge. Consequently, the Abruzzo region has an inhomogeneous distribution of the rain gauges, with station density decreasing with the altitude reaching approximately 1500 m a.s.l. Notwithstanding, pluviometric inflow spatial distribution shows a subregional dependency as a function of four climatic and altimetric factors: coastal, hilly, mountain, and inner plain areas (i.e., Marsica). Such areas are used in this analysis to characterize the radar retrieval vs. rain gauge amounts in each of those zones. Compared to previous studies on the topic, the analysis presented the importance of an accurate selection of the climatic and altimetric subregional areas where the radar vs. rain gauge comparison is undertaken. This aspect is not only of great importance to correct biases in radar retrieval in a more selective way, but it also paves the way for more accurate hydrometeorological applications (e.g., hydrological model initialization and quantification of aquifer recharge), which, in general, require the accurate knowledge of rain amounts upstream of a basin. To fill the gap caused by the uneven rain gauge distribution, ordinary Kriging (OK) was applied on a regional scale to obtain 2D maps of rainfall data, which were cumulated on a monthly and yearly basis. Weather radar data from the Italian mosaic were also considered, in terms of rain rate retrievals and cumulations performed on the same time frame used for rain gauges. The period considered for the analysis was two continuous years: 2017 and 2018. The output of the elaborations included raster maps for both radar and interpolated rain gauges, where each pixel contained a rainfall quantity. Although the results showed a general underestimation of the weather radar data, especially in mountain and Marsica areas, they were within the 95% confidence interval of the OK estimation. Our analysis highlighted that the average bias between radar and rain gauges, in terms of precipitation amounts, was a function of altitude and was almost constant in each of the selected areas. This achievement suggests that after a proper selection of homogeneous target areas, radar retrieval can be corrected using the denser network of rain gauges typically distributed at lower altitudes, and such correction can be extended at higher altitudes without loss of generality.@en

The hilly landscape of the Periadric area in Central Italy is characterized by mainly marly– clayey foredeep basin deposits (Plio–Pleistocene age). These lithotypes are generally considered aquicludes, if compared with the regional limestone aquifers of Apennines. However, a coarsening upward trend characterizes the upper portion of this stratigraphic sequence, with arenaceous deposits and even conglomerates on the top. From a geomorphological viewpoint, the areas with coarser outcrops show a flat shape and sub‐vertical slopes, like boundaries. At the base of these scarps, springs can be found at the interface between coarse and fine deposits, whereas these arenaceous bodies are actual aquifers. Until now, the hydrodynamics and hydrochemical features of this kind of aquifer have not been investigated deeply, because they have always been considered a worthy water resource. However, they could play a crucial role in integrated water management, especially to cope with climate changes and drought periods. Considering these, the main purpose of this study was to investigate from a hydrogeological point of view and to assess the groundwater quantity and quality. Five examples throughout the Abruzzo region were considered. For evaluation and comparisons between water resources, the water volume that infiltrates yearly at each squared kilometer of an aquifer (Mm³/y/km²) was applied. This value was calculated through three different approaches to provide a recharge estimation for this kind of aquifer that is as exhaustive and representative as possible. The results allowed us to characterize the hydrogeological model and to quantify the resources between 0.1 and 0.16 Mm³/y/km², to be suitable for multi–purpose utilization.

@en