Ultrasound sensors based on integrated photonics devices provide a new solution to meet the miniaturization demand for the detection functionality of transducers. An important example is the silicon ring-resonator (RR) ultrasound sensor developed in our department. This sensor combines a small footprint with high sensitivity and a low detection limit. Compared with piezoelectric transducers, it has additional advantages of low cost, mass producibility, and immunity to electromagnetic interference. It is also possible to build an array of these RR sensors on a single chip. These merits make the sensor appealing for ultrasound detection in general. However, there are three challenges that have arisen from this previous work on the RR ultrasound sensor. These challenges relate to specific properties of such silicon RR ultrasound sensors and to the high sensitivity of silicon integrated photonics devices to fabrication variations. More specifically, difficulties in interrogating RR ultrasound sensors need to be overcome. Further, inherent drawbacks of RR ultrasound sensors need to be addressed, suggesting to look for an alternative silicon integrated photonics ultrasound sensor. Finally, design methods need to be developed for making RRs and Mach-Zehnder interferometers (MZIs), which are widely used in silicon photonics, robust to fabrication variations. This thesis addresses the three challenges sequentially. We developed an integrated photonics interrogator to better read out the RR sensor, a silicon MZI based ultrasound sensor to overcome the RR sensor's drawbacks, and design methods for silicon RRs and MZIs with a free spectral range insensitive to fabrication variations. @en

We report a highly sensitive ultrasound sensor based on an integrated photonics silicon Mach-Zehnder interferometer (MZI). One arm of the MZI is located on a thin membrane, acting as the sensing part of the device. Ultrasound waves excite the membrane's vibrational mode, thus inducing modulation of the MZI transmission. The measured sensor transfer function is centered at 0.47 MHz and has a -6 dB bandwidth of 21.2%. For 1.0 mW optical input power, we obtain a high sensitivity of 0.62 mV/Pa, a low detection limit of 0.38 mPa/Hz^1/2 at the resonance frequency and a large dynamic range of 59 dB. In preliminary ultrasound imaging experiments using this sensor, an image of a wire phantom is obtained. The properties of this sensor and the generated image show that this sensor is very promising for ultrasound imaging applications.

@en

A highly sensitive ultrasound sensor based on an integrated photonics Mach–Zehnder interferometer (MZI) fabricated in silicon-on-insulator technology is reported. The sensing spiral is located on a membrane of size 121 μm × 121 μm. Ultrasound waves excite the membrane’s vibrational mode, which translates to modulation of the MZI transmission. The measured sensor transfer function is centered at 0.47 MHz and has a −6 dB bandwidth of 21.2%. The sensor sensitivity is linear in the optical input power and reaches a maximum 0.62 mV/Pa, which is limited by the interrogation method. At 0.47 MHz and for an optical power of 1.0 mW the detection limit is 0.38 mPa∕Hz ¹ ∕ ² and the dynamic range is 59 dB. The MZI’s gradual transmission function allows a wide range of wavelength operation points. This strongly facilitates sensor use and is promising for applications.

@en

We propose a design method for silicon ring resonators (RRs) with a free spectral range (FSR) insensitive to fabrication variations. Two waveguide-core widths are used in the RR, with opposite signs of the group-index derivative with respect to the width. This results in cancellation of the width-dependent FSR changes. The systematic deviation of the realized width from the design width is determined and is used for calibrating the calculated relation of group index versus width. This enables a more accurate FSR value and well-aimed robust performance. We present two robust design examples. Experimental results match well with the predictions. For the deliberately introduced ±10 nm core-width change, the FSR variation of the robust designs is only about 30% of the value measured from the RR with a single core width. This design method can be used to improve the performance of photonic integrated circuits using multiple RRs. As the FSR of a RR is not easily tunable, the robust design is beneficial to applications where an accurate FSR is required, such as in microwave photonics.

@en

We present a compact integrated photonics interrogator for a ring-resonator (RR) ultrasound sensor, the so-called MediGator. The MediGator consists of a special light source and an InP Mach-Zehnder interferometer (MZI) with a 3 × 3 multi-mode interferometer. Miniaturization of the MZI to chip size enables high temperature stability and negligible signal drift. The light source has a −3 dB bandwidth of 1.5 nm, a power density of 9 dBm/nm and a tuning range of 5.7 nm, providing sufficient signal level and robust alignment for the RR sensor. The mathematical procedure of interrogation is presented, leading to the optimum MZI design. We measure the frequency response of the sensor using the MediGator, giving a resonance frequency of 0.995 MHz. Further, high interrogation performance is demonstrated at the RR resonance frequency for an ultrasound pressure range of 1.47 − 442.4 Pa, which yields very good linearity between the pressure and the resulting modulation amplitude of the RR resonance wavelength. The measured signal time traces match well with calculated results. Linear fitting of the pressure data gives a sensor sensitivity of 77.2 fm/Pa. The MediGator provides a low detection limit, temperature robustness and a large measurement range for interrogating the RR ultrasound sensor.

@en

We experimentally demonstrate an interrogation procedure of a ring-resonator ultrasound sensor using a fiber Mach-Zehnder interferometer (MZI). The sensor comprises a silicon ring resonator (RR) located on a silicon-oxide membrane, designed to have its lowest vibrational mode in the MHz range, which is the range of intravascular ultrasound (IVUS) imaging. Ultrasound incident on the membrane excites its vibrational mode and as a result induces a modulation of the resonance wavelength of the RR, which is a measure of the amplitude of the ultrasound waves. The interrogation procedure developed is based on the mathematical description of the interrogator operation presented in Appendix A, where we identify the amplitude of the angular deflection Φ0 on the circle arc periodically traced in the plane of the two orthogonal interrogator voltages, as the principal sensor signal. Interrogation is demonstrated for two sensors with membrane vibrational modes at 1.3 and 0.77 MHz, by applying continuous wave ultrasound in a wide pressure range. Ultrasound is detected at a pressure as low as 1.2 Pa. Two optical path differences (OPDs) of the MZI are used. Thus, different interference conditions of the optical signals are defined, leading to a higher apparent sensitivity for the larger OPD, which is accompanied by a weaker signal, however. Independent measurements using the modulation method yield a resonance modulation per unit of pressure of 21.4 fm/Pa (sensor #1) and 103.8 fm/Pa (sensor #2).@en