Nitrate concentrations exceed standards in many drinking water sources. Solid carbon source (SCS) is usually used to increase the biological denitrification in waters with a low carbon‑nitrogen ratio. However, there is a lack of research on the enhanced denitrification in drinking water sources with nitrate exceeding limits by the introduction of SCS. In this study, a SCS composite was prepared using agricultural waste corncob and polybutylene succinate and the SCS carbon release performance, denitrification effect and potential chemical and biological risks were investigated via a series of batch and column experiments. The SCS composite presented a long-term, stable carbon release performance and good microbial utilization capability for denitrification: SCS composite has a sustained release capacity for over 28 days in dynamic waters. Short-chain fatty acids accounted for over 60 % of the released carbon, and predominant fluorescence compounds were protein organic compounds and soluble microbial metabolites. The introduction of SCS composite evidently improved bio-rope biomass and its denitrification effect. The removal percentage of NO₃⁻ by SCS reactor pretreatment reached 90.9 %, remaining stable within 28 days. The SCS pretreatment increased formation potentials of trihalomethanes, but formation potentials of haloacetonitriles with higher toxicity were effectively reduced, so the comprehensive toxicity risk of disinfection by-products was reduced. The SCS pretreatment has slight negative impact on drinking water biological stability only during the first 10 days, which needs attention. This study demonstrated that the prepared SCS composite has excellent carbon release performance and denitrification effect, and its chemical and biological risks were controllable.

@en

In drinking water treatment plants (DWTPs), the widely used biological activated carbon filters (BACFs), as the last barrier before disinfection, can remove dissolved organic matter (DOM) known as precursors of disinfection by-products (DBPs). Whether phosphate addition can improve water purification and DBP control of BACFs is still controversial. This study investigated short-term and long-term effects of phosphate addition on controlling DBP formation potentials (FPs) by BACFs via column and batch experiments. The BAC columns presented good water purification performance: they removed around 50 % DOM, nearly all fulvic acid-likes and humic acid-likes as well as 5 %–70 % chlor(am)innated THM4, HAA9 and HAN4 FPs (except chloraminated THM4 FPs)， which was mainly contributed by aerobic bacteria not anoxic bacteria. Phosphate addition within 7–14 days further improved removals of DOM, aromatic organics, fluorescence fractions in DOM as well as HAA9 and HAN4 FPs (especially TCAA FP and TCAN FP) to different extent. However, this improvement did not last longer, and removals of DOM, aromatic organics, two fluorescence fractions (soluble microbial byproduct-likes and humic acid-likes) and DBP FPs decreased despite long-term phosphate addition. Oxic and anoxic batch experiments showed that the positive response of water purification to short-term phosphate addition was also mainly attributed to aerobic bacteria and not to anoxic bacteria. For example, the former decreased DOM and DBP FPs, while the latter increased protein- and tryptophan-like substances as well as chloraminated THM4 FPs. Phosphate addition resulted in EPS increase in anoxic reactors and decrease in oxic reactors. These results indicated that a high dissolved oxygen in BACFs may be helpful for water purification and DBP control. Overall, short-term phosphate addition into phosphorus-limited water is beneficial for BACFs to control DBPs while long-term addition has no effect. Therefore, an intermittent phosphate addition into BACFs is suggested to control DBPs in DWTPs.@en

Biological activated carbon (BAC) filtration is usually considered to be able to decrease formation potentials (FPs) of disinfection by-products (DBPs) in drinking water treatment plant (DWTP). However, BAC filters with long running time may release microbial metabolites to effluents and therefore increase FPs of nitrogenous DBPs with high toxicity. To verify this hypothesis, this study continuously tracked BAC filters in a DWTP for one year, and assessed effects of old (running time 8–9 years) and new (running time 0–13 months) BAC filters on FPs of 15 regulated and unregulated DBPs. Results revealed that dissolved organic carbon (DOC) removal was slightly higher in the new BAC than the old one. All fluorescent components of dissolved organic matter evidently declined after new BAC filtration, but fulvic acid-like and soluble microbial product-like substances increased after old BAC filtration, which could be caused by microbial leakage. Correspondingly, new BAC filter generally removed more DBP FPs than the old one. 46.5% HAA7 FPs from chlorination and 44.3% THM4 FPs from chloramination were removed by new BAC filter. However, some DBP FPs, especially HAN FPs, were poorly removed or even increased by the old BAC filter. Proteobacteria could be a main contributor for DBP precursor removal in BAC filters. Herminiimonas, most abundant genera in new BAC filter, may explain its better DOC and UV254 removal performance and lower DBP FPs, while Bradyrhizobium, most abundant genera in old BAC filter, might produce more extracellular polymeric substances and therefore increased N-DBP FPs in old BAC effluent. This study provided insight into variations of DBP FPs and microbial communities in the new and old BAC filters, and will be helpful for the optimization of DWTP design and operation for public health.@en