Accurate evaluation of undrained shear strength of soils is crucial in geotechnical design and assessment. In the practice, undrained shear strength is obtained most frequently from CPT data, dividing the net cone tip resistance by a cone factor, 𝑁𝑁!". For organic soils, values between 8.6 and 15.3 are reported, depending on the stress history. The cone factor can be conditioned to the results of laboratory tests, although uncertainties remain on the variety of stress paths followed by the soil elements around the tip of the cone, compared to the ones tested in the laboratory. Non-uniqueness in the definition of the cone factor may lead to either unsafe or over-conservative choices, partly undermining both the reliability and the sustainability of the design. This contribution analyses numerically the inversion technique used to determine the undrained shear strength of organic clays, exploiting data from an extensive in situ and laboratory investigation. The adopted constitutive model was calibrated on the results of laboratory tests. Cone penetration tests were simulated performing coupled hydro-mechanical numerical analyses via G-PFEM, developed in the last decade at CIMNE-UPC. The role played by initial stress state and previous stress history upon stress distribution at failure, cone factor and sleeve friction is discussed. The numerical results suggest how the sleeve friction could be used to condition the cone factor depending on the over-consolidation ratio and demonstrate how combining the different available CPT readings with the aid of numerical results may reduce the uncertainty in the estimation of undrained shear strength.@en

Anchored wire meshes are commonly adopted to stabilize potentially unstable soil slopes. This reinforcement technique, employed either as an active or a passive anchoring system, is commonly designed according to ultimate limit state approaches. In this paper, an interaction model, useful for the design of anchored wire meshes, is proposed. The model is based on the results of a series of 3D large displacement finite element numerical analyses, in which the wire mesh mechanical behaviour is modelled as either an elastic or an elastic–plastic membrane. The model is inspired to standard load–displacement curves for shallow foundations, and the wire mesh presence is taken into account by suitably modifying the bearing capacity formula. The proposed model predictions are compared with experimental punching test results. The use of the model, only requiring the definition of geometry and soil–wire mesh mechanical properties, allows the pre-design of the reinforcement system without performing ad hoc finite element numerical analyses.

@en