Individual overtopping volumes, water layer thickness and front velocities at rubble mound breakwaters with a smooth crest in shallow water

Abstract

Individual overtopping events are important variables when designing a coastal structure as they can deviate significantly from the mean overtopping discharge. Thus, in this study, extreme overtopping events at rubble mound structures with a smooth crest in shallow water have been studied. Both the water layer thickness (flow depth), front velocity and individual overtopping volumes are measured in a wave flume for typical coastal structures with a smooth crest in shallow water for a large range of hydraulic conditions and three different foreshore slopes. An analysis of the individual overtopping volumes shows that the largest individual overtopping volumes arise from short waves that travel on the crest of a low-frequency wave in shallow water and short waves that travel on top of the trough in deep water. Due to the temporal water level variation caused by the low-frequency waves in shallow water, there are fewer overtopping events compared to deep water conditions with the same non-dimensional overtopping discharge. However, the individual overtopping volumes of these events are larger. To quantify the extreme overtopping variables, an empirical formulation based on the relative crest height and short-wave steepness is proposed for the non-dimensional 2 % exceedance water layer thickness, front velocity and individual overtopping volume in terms of incident waves with an R² of 0.84, R² of 0.55 and R² of 0.85 respectively. A further small improvement is found when the low-frequency wave height and 2% exceedance wave height are included, but the added value of this expression does not outweigh the additional wave variables needed for the expression. A log-normal distribution with a constant shape and an expression for the scale of the distribution is proposed to describe the distribution of the individual overtopping volumes in shallow water which accurately captures the distribution (R² of 0.90). Compared to most of the current design approach which is based on a cascade of empirical formulations, this is a significant improvement. In addition, the reasonable results for a distribution with a constant shape parameter show that the shape of the distribution does not change significantly for shallow water conditions.