Consistency of Mechanical Properties of 3D Printed Strain Hardening Cementitious Composites Within One Printing System

Book chapter (2022)

Authors

Karsten Nefs Eindhoven University of Technology
A.L. van Overmeir Materials and Environment - CEG
Theo A.M. Salet Eindhoven University of Technology
A. S.J. Suiker Eindhoven University of Technology
B. Šavija Materials and Environment - CEG
E. Schlangen Materials and Environment - CEG
Freek Bos Eindhoven University of Technology
Research Group
Materials and Environment (CEG) (TU Delft)
Copyright: © 2022 Karsten Nefs, A.L. van Overmeir, Theo A.M. Salet, A. S.J. Suiker, B. Šavija, E. Schlangen, Freek Bos
DOI: https://doi.org/10.1007/978-3-031-06116-5_22
More Info
expand_more

Published Date

2022

Language

English

Reuse Rights

Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.

Faculty

Civil Engineering & Geosciences

Department

Materials- Mechanics- Management & Design

Research Group

Materials and Environment

Abstract

Previous research has shown that the material properties of a three-dimensional printed strain hardening cementitious composite (3DP-SHCC) can significantly vary, depending on the printing system with which it is produced. However, limited research has been performed on the reproducibility of hardened mechanical properties under identical printing conditions. In this study, the consistency of hardened properties, including compressive strength, flexural strength and deflection, and tensile strength and strain, was tested from materials printed during three separate but identical printing sessions. The research shows that with 3DP-SHCC, significant variations in mechanical properties between printing sessions can be expected.

Files

Nefs2022_Chapter_ConsistencyOf... (pdf)
(pdf | 0.546 Mb)
- Embargo expired in 25-12-2022
Unknown license