Coastal boulder deposits hold the potential to aid in the reconstruction of past extreme wave events. However, commonly used hydrodynamic equations for calculating wave heights from transported boulders can be inaccurate. New and alternative methods need to be explored in an interdisciplinary way to ensure a more complete picture of the phenomenon of boulder transport is achieved. Through the use of a physical experiment, this study aims to investigate the influence of different tsunami wave types, wave parameters and boulder shapes on boulder transport distance. The experimental results also allow for a novel application of dimensional analysis to enable comparisons with other experiments as well as a field case study. In the experiment an elongate irregularly shaped boulder showed transport distances up to 1 m farther than a cuboid shaped boulder under the influence of the same waves. The irregularly shaped boulder had a predominant transport mode of rolling, whereas the cuboid shaped boulder predominantly underwent sliding transport. Tsunami wave type also influenced boulder transport distances, with N-waves frequently showing greater transport than E-waves of a comparable wave steepness. Key offshore wave and boulder parameters were then compared through dimensional analysis using Buckingham's Pi Theorem, enabling comparisons to other datasets to be made. Data from another published experimental study and a field study in Settai, Japan, showed reasonable agreement, particularly for the shorter period field data. These findings emphasize the importance of incorporating boulder shape, wave type, and dimensional analysis into future studies, providing a foundation for more accurate reconstructions of past tsunami events.@en

After an earthquake, a rapid identification of the damaged building stock is crucial to prioritise rescue operations, ensure primary services to the most affected regions and support reconstruction. Whilst in-situ reconnaissance missions provide invaluable data on the intensity and distribution of earthquake-induced structural damage, the process of collecting field observations is often dangerous, expensive, and is usually undertaken a few weeks after the disaster. Spaceborne Synthetic Aperture Radar (SAR) can remotely provide imagery data of wide affected areas, enabling to reach locations that are difficult or dangerous to access with traditional survey methods. Furthermore, SAR-based observations are independent from daylight illumination and clear-weather conditions. Thanks to the recent availability of Very-High Resolution (VHR) SAR satellites, post-disaster imagery data with sub-metre resolution are now available within a few hours after a major earthquake, opening unprecedented opportunities for complementing in-situ operations. The textural analysis of post-earthquake VHR SAR images could be used to identify backscattering signatures that are likely associated with building damage. However, application has been limited by the lack of methods that correlate the textural properties of damaged structures in radar images with building survey data. In this paper, we present a method using textural features derived from VHR SAR post-event images in combination with building survey data to classify earthquake-induced building damage at city block-level. We tested the proposed method within the context of a joint Structural Extreme Event Reconnaissance (StEER), GeoHazards International (GHI) and Earthquake Engineering Field Investigation Team (EEFIT) mission that followed the 2021 Haiti Earthquake. The developed method was applied to the city of Les Cayes, Haiti, using a post-event Capella SAR image acquired on the 16th of August 2021. The outcomes can positively impact future earthquake scenarios, with the potential to improve rapid disaster response and remotely aid post-earthquake reconnaissance missions.@en

Remote reconnaissance missions are promising solutions for the assessment of earthquake-induced structural damage and cascading geological hazards. Space-borne remote sensing can complement in-field missions when safety and accessibility concerns limit post-earthquake operations on the ground. However, the implementation of remote sensing techniques in post-disaster missions is limited by the lack of methods that combine different techniques and integrate them with field survey data. This paper presents a new approach for rapid post-earthquake building damage assessment and landslide mapping, based on Synthetic Aperture Radar (SAR) data. The proposed texture-based building damage classification approach exploits very high resolution post-earthquake SAR data integrated with building survey data. For landslide mapping, a backscatter intensity-based landslide detection approach, which also includes the separation between landslides and flooded areas, is combined with optical-based manual inventories. The approach was implemented during the joint Structural Extreme Event Reconnaissance, GeoHazards International and Earthquake Engineering Field Investigation Team mission that followed the 2021 Haiti Earthquake and Tropical Cyclone Grace.

@en

Post-earthquake reconnaissance missions are critical to understand the event characteristics, identify building and infrastructure vulnerabilities, and improve future construction practice. However, in-field missions can present logistic and safety challenges that do not make them viable in every post-disaster scenario. Remote sensing technique can be used to rapidly collect a large amount information that can be used to enrich the post-event learning process. While the possibility to deploy teams in the field remain a valuable asset for an integrated understanding of technical and socio-economic factors, a mix of remote and in-field reconnaissance activities can be a way forward in post-disaster management. This work presents the results of a hybrid mission mobilised by the Earthquake Engineering Field Investigation Team (EEFIT) after the 2021 Haiti earthquake. On 14 August 2021, a 7.2 magnitude earthquake struck the Tiburon Peninsula in the Caribbean nation of Haiti, approximately 150km east of the capital Port au Prince. The event was followed by numerous aftershocks up to magnitude 5.7, and tiggered over 1000 landslides. Over 2000 people lost their lives, with over 15,000 injured and over 137,000 houses damaged or destroyed. The estimated economic impact is of the order of US$1.6 billion. Due the complex political and security situation in Haiti, coupled with the global pandemic, a full in field mission was not considered feasible, so a hybrid mission was designed instead. First, open-source information was collected and used to characterise the seismic event, analyse the strong ground motion and compare to established national and international earthquake codes and standard. Second, remote sensing techniques including Interferometric Synthetic Aperture Radar (InSAR) and Optical/Multispectral imagery were used to understand the earthquake mechanism, the ground displacement distribution and the possibility to detect landslide on a regional scale. The general applicability of remote sensing technique in the context of post disaster assessment was also evaluated. Finally, the earthquake impact on different building typologies in Haiti was investigated through the damage assessment of over 2000 buildings comprising schools, hospitals, churches and housing. This was done in collaboration with the Structural Extreme Events Reconnaissance (StEER) team, who mobilised a team of local non-experts to rapidly record building damage. This talk summarises the mission setup and findings, and discusses the benefits of and difficulties encountered during this hybrid reconnaissance.@en

On 14th August 2021, a magnitude 7.2 earthquake struck the Tiburon Peninsula in the Caribbean nation of Haiti, approximately 150 km west of the capital Port-au-Prince. Aftershocks up to moment magnitude 5.7 followed and over 1,000 landslides were triggered. These events led to over 2,000 fatalities, 15,000 injuries and more than 137,000 structural failures. The economic impact is of the order of US$1.6 billion. The on-going Covid pandemic and a complex political and security situation in Haiti meant that deploying earthquake engineers from the UK to assess structural damage and identify lessons for future building construction was impractical. Instead, the Earthquake Engineering Field Investigation Team (EEFIT) carried out a hybrid mission, modelled on the previous EEFIT Aegean Mission of 2020. The objectives were: to use open-source information, particularly remote sensing data such as InSAR and Optical/Multispectral imagery, to characterise the earthquake and associated hazards; to understand the observed strong ground motions and compare these to existing seismic codes; to undertake remote structural damage assessments, and to evaluate the applicability of the techniques used for future post-disaster assessments. Remote structural damage assessments were conducted in collaboration with the Structural Extreme Events Reconnaissance (StEER) team, who mobilised a group of local non-experts to rapidly record building damage. The EEFIT team undertook damage assessment for over 2,000 buildings comprising schools, hospitals, churches and housing to investigate the impact of the earthquake on building typologies in Haiti. This paper summarises the mission setup and findings, and discusses the benefits, and difficulties, encountered during this hybrid reconnaissance mission.@en