Objectives: Hand hygiene has long been promoted as the most effective way to prevent the transmission of infection. However, due to low compliance and low quality of hand hygiene reported in previous studies, constant monitoring of hand hygiene compliance and quality among healthcare workers is crucial. This study investigated the feasibility of using a thermal camera with an RGB camera to detect hand coverage of alcohol-based formulation, thereby monitoring the quality of hand rubbing. Methods: In total, 32 participants were recruited to participate in this study. Participants were required to perform four types of hand rubbing to achieve different coverage of the alcohol-based formulation. After each task, participants' hands were photographed under a thermal camera and an RGB camera, while an ultraviolet (UV) test was used to provide the ground truth of hand coverage of alcohol-based formulation. U-Net was used to segment areas exposed to alcohol-based formulation from thermal images, and system performance was evaluated by comparing differences in coverage between thermal images and UV images in terms of accuracy and Dice coefficient. Results: This system found promising results in terms of accuracy (93.5%) and Dice coefficient (87.1%) when observations took place 10 s after hand rubbing. At 60 s after hand rubbing, accuracy and Dice coefficient were 92.4% and 85.7%. Conclusions: Thermal imaging has potential for accurate, constant and systematic monitoring of the quality of hand hygiene.

We present a fully-printable method to embed interactive information inside 3D printed objects. The information is invisible to the human eye and can be read using thermal imaging after temperature transfer through interaction with the objects. Prior methods either modify the surface appearance, require customized devices or not commonly used materials, or embed components that are not fully 3D printable. Such limitations restrict the design space for 3D prints, or cannot be readily applied to the already deployed 3D printing setups. In this paper, we present an information embedding technique using low-cost off-the-shelf dual extruder FDM (Fused Deposition Modeling) 3D printers, common materials (e.g., generic PLA), and a mobile thermal device (e.g., a thermal smartphone), by leveraging the thermal properties of common 3D print materials. In addition, we show our method can also be generalized to conventional near-infrared imaging scenarios. We evaluate our technique against multiple design and fabrication parameters and propose a design guideline for different use cases. Finally, we demonstrate various everyday applications enabled by our method, such as interactive thermal displays, user-activated augmented reality, automating thermal triggered events, and hidden tokens for social activities.