In this work, numerical simulations are performed to predict two-phase annular flow of refrigerant R245fa inside a 3.4 mm diameter vertical channel. The VOF (Volume of Fluid) method implemented in an OpenFOAM solver is used to accurately track the vapor-liquid interface. A 2D axisymmetric domain is considered and the Adaptive Mesh Refinement (AMR) method is applied to the cells near the liquid/vapor interface. The Reynolds-Averaged Navier Stokes (RANS) equations are solved and the k-ω SST model is adopted for turbulence modelling in both the liquid and vapor phase. Simulations are used to calculate instantaneous and mean values of the liquid film thickness at mass flux G = 100 kg m^-2 s^-1 and vapor quality ranging between 0.2 and 0.85. Numerical results are compared against measurements of the liquid film thickness taken during vertical annular downflow. Previous works from the literature and the deviations observed between present numerical and experimental results suggest the need for turbulence damping at the vapor-liquid interface by adding a source term in the ω equation. The simulations show that a low value of the turbulence damping parameter (e.g. 1) causes the average liquid film thickness to increase by 25 %–52 % compared to the non-damped scenario. The interface presents large amplitude disturbance waves in the non-damped case, whereas small ripple waves are predicted when turbulence damping is introduced. Furthermore, the difference between the application of a symmetric and asymmetric treatment for the source term is analysed. From the comparison between experimental data and numerical simulations, it emerges that the value of the correct damping source term to be applied is strictly dependent on the vapor quality.

In annular downward flow, an annular liquid film flows at the perimeter of the channel pushed down by the gravity force and by the shear stress that the vapor core exerts on it. Depending on the working conditions, the vapor-liquid interface can be flat or rippled by waves. The knowledge of the liquid film thickness is very important for the study of annular flow condensation because the thermal resistance of the liquid is often the most important parameter controlling the heat transfer. A new approach for the simulation of annular flow is here proposed using an in-house developed transient solver based on the Volume of Fluid (VOF) adiabatic solver interIsoFoam available in OpenFOAM. With the VOF method, in addition to the standard set of equations (continuity and momentum), a transport equation related to the advection of the volume fraction scalar field has to be solved. The numerical setup consists of 2D axisymmetric domain. An adaptive mesh refinement (AMR) method is added to the solver to better capture the interface position. The k-ω SST model is used for turbulence modelling in both the liquid and vapor phases and a source term (whose magnitude is controlled by a model parameter named B) is included in the ω equation to damp the turbulence at the interface.