Hexavalent chromium is one of the toxic metals in water pollution. This study is aimed at analyzing the involvement of chromium reductase and biosorption potential in chromium-resistant species of Bacillus cereus. A total of 10 % (v/v) of B. cereus biomass was inoculated into a 90 mL chromium-contaminated solution with an initial concentration of 60 mg/L. Biomass digestion was carried out every day for a 5-day treatment period for chromium content analysis, while biomass characterization was carried out at the end of the treatment period, comparing the exposed vs. non-exposed bacteria. Results indicated that the highest chromium removal (16.12 ± 0.63 %) was obtained on day 3, while the maximum biosorption capacity was obtained on day 1, reaching 0.461 ± 0.02 mg Cr/g dry cell of biomass. XRD showed the crystalline structure of the bacteria cell after being exposed to chromium, suggesting that interactions between polysaccharides and proteins in the membrane may occur during the treatment. In addition, FT-IR spectra also showed decreasing peaks and the involvement of hydroxyl, carboxyl, carbonyl, and nitroxide groups during the treatment. SEM-EDX results indicated that bacteria are experiencing cell structure alteration with more intense chromium spectra on the surface, while TEM images showed endospore formation by B. cereus under adverse environmental conditions. This study suggested that the removal of hexavalent chromium by B. cereus might be dominant via biosorption (translocated into cell biomass).

@en

Increasing aquaculture cultivation produces large quantities of wastewater. If not handled properly, it can have negative impacts on the environment. Constructed wetlands (CWs) are one of the phytoremediation methods that can be applied to treat aquaculture effluent. This research was aimed at determining the performance of Cyperus rotundus in removing COD, BOD, TSS, turbidity, ammonia, nitrate, nitrite, and phosphate from the batch CW system. Treatment was carried out for 30 days with variations in the number of plants (10, 15, and 20) and variations in media height (10, 12, and 14 cm). The result showed that aquaculture effluent contains high levels of organic compounds and nutrients, and C. rotundus can grow and thrive in 100% of aquaculture effluent. Besides that, the use of C. rotundus in CWs with the effect of numbers of plants and media height showed performance of COD, BOD, TSS, turbidity, ammonia, nitrate, nitrite, and phosphate with 70, 79, 90, 96, 64, 82, 92, and 48% of removal efficacy, respectively. There was no negative impact observed on C. rotundus growth after exposure to aquaculture effluent, as indicated by the increase in wet weight, dry weight, and growth rate when compared to the control. Thus, adding aquaculture effluent to CWs planted with C. rotundus supports the growth and development of plants while also performing phytoremediation.

@en

Oil is still the main source of energy in various sectors, such as transportation, industries, and electricity. As one of the developing countries, Indonesia has enormous activities related to oil, including drilling, transporting, and refining. This paper aimed to provide a review of the cases of oil spills in the Indonesian coastal area as an impact of oil-related activities. Most of the Indonesian oil spill cases occurred due to tanker leakage, pipe leakage, and ship accidents. Most of the well-documented and reported cases of oil spills in the Indonesian coastal area occurred in Java Region, with PT Pertamina (a government-owned oil and gas company) and its subsidiaries being the primary parties commonly involved in the accidents. The ecological impacts of the oil spill, including those on plankton, benthos, fish, birds, and vegetation, are then elaborated in detail. Additionally, health risks to humans are also intensively discussed, presenting acute and long-term exposure effects. This paper presents oil spill management strategies, focusing on the mitigations and regulations related to previous cases, in which cleanup operations and financial compensations were the most frequently implemented mitigation efforts. This paper also lists the options for technologies, including physical, chemical, and biological methods, in an effort to clean up oil spills. Monitoring the adverse effects of oil spills on human health and creating local-specific contingency plans are suggested to be conducted for future research directions.

@en

In this study, biosorption potential of nine epiphytic bacteria isolated from the rhizosphere of Lepironia articulata and Scirpus grossus were assessed. Identification of the isolated epiphytic rhizobacteria using 16S rRNA analysis showed species belonging to the four genera of Bacillus, Enterobacter, Aeromonas, and Chromobacterium. Batch biosorption studies were carried out to assess the capacity of the isolated bacteria to act as Pb and Cu biosorbents. Different initial concentrations of the two heavy metals (50, 100, 200, 300, and 400 ppm) were used to determine the ability of the biosorbent to reach a tolerance level and then calculate the percentage of biosorption with respect to 0.1 g dry weight. Initial concentration of Pb and Cu exposed showed that the isolated bacteria have high tolerance up to 400 ppm. Bacteria prefer Pb ions over Cu, which is indicated by higher removal of Pb in all tested reactors. Bacillus sp. (coded Sc1) showed the highest biosorption capacity with 100% Pb and 97% Cu removal.

@en

Heavy metal and microplastic pollutions are prevalent in freshwater ecosystems, with many freshwater bodies being contaminated by one or both of these pollutants. Recent studies reported extreme detections of Cd, Pb and Zn, high concentrations of Cr, Pb and Cu and microplastics acting as vectors of pollutants, including heavy metals. Mayflies can serve as bioindicators of heavy metal contamination in freshwater ecosystems because changes in their community structure, physiology, and behaviour can reflect and help predict the concentrations of metals in these environments. This review discusses the ecological alterations induced by tissue metal concentration in mayflies and other macroinvertebrates. As sensitive taxa to heavy metal contamination, mayflies can reflect the impacts of this pollution through their ethology and relationship to the substrate, highlighting issues such as eutrophication, alterations in community structure, inhibitory effects and sediment toxicity. Mayflies are also highly affected by microplastic exposure, which leads to ingestion, bioaccumulation, biomagnification, habitat and community alteration, behavioural changes, physiology alteration and toxicity. Mayflies bioindication metrics for assessing the impact of heavy metals and microplastics include the examination of community alteration, functional feeding behaviour, molecular structure, dietary and toxicity impacts, bioaccumulation and biomagnification and biomarkers. Current challenges for the utilization of mayflies as bioindicators include temporal variations in sensitivity, lack of universally recognised protocols and need for standardised protocols for microplastic analysis. Additionally, the applicability of mayflies as bioindicators may vary across different ecosystems, emphasising the need for selecting suitable indicators that align with the unique characteristics of the ecosystem.

@en

Tofu effluent contains a high concentration of organic materials, nutrients, suspended solids and is also low in pH. This research was aimed at applying phytotreatment using floating plant species of Pistia stratiotes to polish tofu effluent before final discharge into water bodies while also producing biogas from the resultant biomass after treatment. A range-finding test (RFT) was conducted to determine the initial concentration to be treated and resulted in 10 % tofu effluent. Phytotreatment was conducted for a period of 14 days, focusing on the removal of organic matter and nutrient contents. After 14 days of treatment, P. stratiotes were able to remove total suspended solids (TSS) by 88 %, ammonia by 42.3 %, phosphate by 50 %, chemical oxygen demand (COD) by 84 %, and biological oxygen demand (BOD) by 95 %, significantly higher as compared to control. Phytotreatment was able to stabilize pH to a neutral value, and P. stratiotes were able to transfer oxygen from air to the rhizosphere area. The maximum daily production of biogas using the plant's biomass was higher as compared to the control; however, the overall biogas accumulation was significantly lower during the 45 days of observation. Further biomass pretreatment was suggested before digestion to obtain higher biogas production since the cellulose, hemicellulose, and lignin content inside the plant biomass were subjected to being hardly degraded by the anaerobic microorganisms.

@en

Bacillus nitratireducens was isolated from textile effluent and showed high tolerance to chromium (Cr), reaching up to a 1000 mg/L MIC value. This research was aimed at utilizing biosorbents from live and dead cells of B. nitratireducens to remove Cr from an aqueous solution. A batch biosorption test was performed, and mechanisms analysis was approached by an adsorption-desorption test, SEM-EDS, and FTIR analysis. Cr removal by dead cells in 25, 50, and 100 mg/L of Cr were 58.99 ± 0.7%, 69.8 ± 0.2%, and 82.87 ± 0.11%, respectively, while that by live cells was 73.08 ± 1.9%, 80.27 ± 6.33%, and 86.17 ± 1.93%, respectively. Live cells showed significantly higher Cr removal and adsorption capacities as compared to dead cells. In all concentrations, absorption contributed more than adsorption to the Cr removal by both live and dead cells. Absorption of Cr was subjected to occur due to passive mechanisms in dead cells while involving some active mechanisms in live cells. SEM-EDS confirmed the detection of Cr on the cell surface, while FTIR revealed the shifting of some peaks after the biosorption test, suggesting interactions between Cr and functional groups. Further TEM analysis is suggested to be conducted as a future approach to reveal the inner structure of cells and confirm the involvement of absorption mechanisms.@en

Coagulation–flocculation is currently the best practice for aquaculture effluent treatment, and biobased compounds are emerging as coagulant/flocculants. This study aimed to characterize the bioflocculant produced from Serratia marcescens and applied it to treat artificial turbid water (kaolin substrate) and real aquaculture effluent using the combination of one variable at a time (OVAT) and response surface methodology (RSM) analyses. The bioflocculant produced by S. marcescens was characterized as anionic flocculant with isoelectric point at pH 1.7 and 13.3. At pH 7, its protein content was 1.3 μg/mL, and its total carbohydrate level was 0.53 mg/L. The bioflocculant consisted of various carboxylic acids and enzyme intermediates, indicating the presence of polysaccharides and protein. Comparison of optimized treatment conditions between OVAT and RSM showed that rapid mixing speed, slow mixing time, and sedimentation time were the most influential factors for coagulation–flocculation. The aquaculture effluent required lower rapid mixing speed (125 rpm) and shorter sedimentation time (39 min) than artificial wastewater (160 rpm and 67 min, respectively). The low performance of the bioflocculant in treating aquaculture effluent was due to the more complex characteristics of real aquaculture effluent compared with those of kaolin substrate. Environmental implications: The characterization of bioflocculant produced by Serratia marcescens in terms of its protein level, total carbohydrate content, and isoelectric point has never been reported. The obtained results may provide an insight into the potential of this compound to substitute widely used chemical flocculants with reliable performance. The findings may also be used as a basis to upscale coagulation–flocculation from being applied to artificial wastewater in the laboratory to treating real wastewater, especially with the use of biobased compounds.

@en

Phytoremediation is one of the green technologies that is friendly to nature, utilizes fewer chemicals, and exhibits good performance. In this study, phytoremediation was used to treat diesel-contaminated sand using a local aquatic plant species, Scirpus mucronatus, by analyzing the amount of total petroleum hydrocarbons (TPHs). Optimization of diesel removal was performed according to Response Surface Methodology (RSM) using Box-Behnken Design (BBD) under pilot-scale conditions. The quadratic model showed the best fit to describe the obtained data. Actual vs. predicted values from BBD showed a total of 9.1 % error for the concentration of TPH in sand and 0 % error for the concentration of TPH in plants. Maximum TPH removal of 42.3 ± 2.1 % was obtained under optimized conditions at a diesel initial concentration of 50 mg/kg, an aeration rate of 0.48 L/min, and a retention time of 72 days. The addition of two species of rhizobacteria (Bacillus subtilis and Bacillus licheniformis) at optimum conditions increased the TPH removal to 51.9 ± 2.6 %. The obtained model and optimum condition can be adopted to treat diesel-contaminated sand within the same TPH range (50–3000 mg/kg) in sand.

@en

Biocoagulants have gained attention as an alternative to chemical coagulants in water and wastewater treatment due to their ability to remove pollutant parameters such as turbidity, suspended solids, color, and organic compounds. Plant-based biocoagulants are currently the most promising due to their abundant availability and reliable performance. A proper preparation of plant-based biocoagulants is required to ensure the active compounds from the plants can be extracted. Plant raw materials are prepared into biocoagulants using drying and grinding, extraction, and purification. In mechanical preparation, drying and grinding exhibit great influence on the performance of plant-based biocoagulants due to the removal of moisture and higher contact with the carrier medium during dissolution. A smaller biocoagulant's size resulted in up to 78 % higher removal of turbidity. In chemical preparation, the oil needs to be removed before extracting the active ingredients to avoid low active compound extraction yields. The defatting of Moringa oleifera seeds showed an 18 % higher protein content. Salt and alcohol extractions were mentioned as superior extraction methods to obtain carbohydrate and protein from plant-based biocoagulants compared to water extraction, with up to a 5 % increment in turbidity removal. Preparation and pretreatment protocols have a great influence on the properties and performance of plant-based biocoagulants. Further extension of research on plant-based biocoagulants should address the problems in the initial characterization of plant material, standard pretreatment and preparation protocols, and real-scale application of plant-based biocoagulants.

@en