Cancer is most frequently treated with antineoplastic agents (ANAs) that are hazardous to patients undergoing chemotherapy and the healthcare workers who handle ANAs in the course of their duties. All aspects related to hazardous oncological drugs illustrate that the monitoring of ANAs is essential to minimize the risks associated with these drugs. Among all analytical techniques used to test ANAs, electrochemistry holds an important position. This review, for the first time, comprehensively describes the progress done in electrochemistry of ANAs by means of a variety of bare or modified (bio)sensors over the last four decades (in the period of 1982–2021). Attention is paid not only to the development of electrochemical sensing protocols of ANAs in various biological, environmental, and pharmaceutical matrices but also to achievements of electrochemical techniques in the examination of the interactions of ANAs with deoxyribonucleic acid (DNA), carcinogenic cells, biomimetic membranes, peptides, and enzymes. Other aspects, including the enantiopurity studies, differentiation between single-stranded and double-stranded DNA without using any label or tag, studies on ANAs degradation, and their pharmacokinetics, by means of electrochemical techniques are also commented. Finally, concluding remarks that underline the existence of a significant niche for the basic electrochemical research that should be filled in the future are presented.

In this work, we have used cyclic voltammetry to investigate the interfacial behavior of cocaine cutting agents at the electrified liquid-liquid interface formed between a solution of the water and 1,2-dichloroethane phases. Among 27 chemical species used to adulterate cocaine street samples, only 8 were detectable in the available potential window. These include procaine, lidocaine, levamisole, hydroxyzine, caffeine, phenylethylamine, diltiazem, and diphenhydramine. From the calibration curves obtained using voltammetric data, we have extracted the electroanalytical parameters such as detection sensitivities, limits of detection, and limits of quantifications. Also, for each electrochemically active drug, we have calculated diffusion coefficients and plotted the ion partition and concentration fraction diagrams. All this information is discussed in a view of the cocaine sensors development focused on its detection from demanding matrix defined by the street samples composition.

In view of enhanced oil recovery, the adsorption behavior of surfactants is usually monitored on smooth model rock surfaces using quartz crystal microbalance with dissipation (QCM-D). However, this is an impractical situation as the effect of the surface roughness of reservoir rocks and its role in surfactant adsorption processes are not yet completely understood. The coupling of electrochemical techniques and QCM-D in one analysis setup (EQCM-D) provides a new methodology to explore complex surfactant adsorption processes. In this work, a uniform, rough, and well-covered model CaCO3 surface was obtained on gold and platinum sensors to model carbonate rocks. This was achieved by the electrochemically formed hydroxide ions in the presence of bicarbonate and calcium ions, by which the controlled deposition of CaCO3 resulted in sensor surface coverages in the range 35-40%. Before using the deposited CaCO3 surfaces, the adsorption of anionic surfactant alcohol alkoxy sulfate (AAS) on a smooth commercially available CaCO3 surface was studied with varying CaCl2 concentrations. For the first time, the structure and characteristics of the formed AAS layer were quantitatively described, indicating the formation of an incomplete bilayer. Compared to the smooth CaCO3 surface, an increase in the frequency shift from 5 to 15 times was observed in sensors covered with rough CaCO3 deposit. This observation was primarily attributed to the rougher surfaces that possess more adsorption sites for AAS binding and also to the effect of liquid trapping, inducing additional frequency shifts. The obtained results show that surfactant adsorption on rough surfaces was vastly different from that on smooth surfaces, and they provide a better understanding of the adsorption behavior of surfactants to mineral surfaces.