Having a reduced number of switches and isolated DC sources yet generating a higher number of voltage levels has been always the challenge when selecting the appropriate Multilevel Inverter (MLI) topology. Nowadays, Single-DC-Source Multilevel Inverter (SDCS-MLI) topologies are being considered as more suitable for many power system applications such as Renewable Energy (RE) conversion systems and electrified transportations compared to the Multiple-DC-Source MLIs (MDCS-MLIs). Moreover, increasing the power rating and minimizing the switching frequency while maintaining reasonable power quality using a SDCS-MLI is an important requirement and a persistent challenge for the industry. Thus, this paper presents a general review on the available SDCS-MLI topologies and future trends. Existing solutions are discussed and analyzed based on their topologies, number of output voltage levels, number of active/passive components, advantages/limitations, maturity, and industrial applications. Furthermore, recommendations for future research and development are suggested in this paper.

The Crossover Switches Cell (CSC) is a recent Single DC-Source Multilevel Inverter (SDCS-MLI) topology with boosting abilities. In grid-connected PV applications, the CSC should be controlled to inject a sinusoidal current to the grid with low THD% and unity power factor, while balancing the capacitor voltage around its reference. These two objectives can be met through the application of a finite control set model predictive control (FCS-MPC) method. Thus, this paper proposes a design of an optimized FCS-MPC for a 9-level grid-tied CSC inverter. The switching actions are optimized using the redundant switching states. The design is verified through simulations and real-time implementation. The presented results show that the THD% of the grid current is 1.73%, and the capacitor voltage is maintained around its reference with less than 0.5 V mean error. To test the reliability of the control design, different scenarios were applied, including variations in the control reference values as well as the AC grid voltage. The presented results prove the good performance of the designed controller in tracking the reference values and minimizing the steady-state errors.