Cycle paths can be used as a route for active transportation or simply to cycle for physical activity and leisure. However, exposure to air pollutants can be boosted while cycling, in urban environments, due to the proximity to vehicular emissions and elevated breathing rates. The objective of this work was to assess the exposure of a cyclist to particles and to chemical elements by combining real-time aerosol mass concentration reading equipment and biomonitoring techniques. PM10 and PM2.5 were measured on three cycle paths located in Lisbon, during weekdays and weekends and during rush hours and off-peak hours resulting in a total of 60 campaigns. Lichens were exposed along cycle paths for 3 months, and their element contents were measured by instrumental neutron activation analysis using the k0 methodology (k0-INAA). Using a bicycle commute route of lower traffic intensity and avoiding rush hours or other times with elevated vehicular congestion facilitate a reduction in exposure to pollutants. The implementation of cycle paths in cities is important to stimulate physical activity and active transportation; however, it is essential to consider ambient air and pollutant sources to create safer infrastructures.@en

Source contribution to atmospheric particulate matter (PM) has been exhaustively modelled. However, people spend most of their time indoors where this approach is less explored. This evidence worsens considering elders living in Elderly Care Centres, since they are more susceptible. The present study aims to investigate the PM composition and sources influencing elderly exposure. Two 2-week sampling campaigns were conducted—one during early fall (warm phase) and another throughout the winter (cold phase). PM10 were collected with two TCR-Tecora® samplers that were located in an Elderly Care Centre living room and in the correspondent outdoor. Chemical analysis of the particles was performed by neutron activation analysis for element characterization, by ion chromatography for the determination of water soluble ions and by a thermal optical technique for the measurement of organic and elemental carbon. Statistical analysis showed that there were no statistical differences between seasons and environments. The sum of the indoor PM10 components measured in this work explained 57 and 53 % of the total PM10 mass measured by gravimetry in warm and cold campaigns, respectively. Outdoor PM10 concentrations were significantly higher during the day than night (p value < 0.05), as well as Ca2+, Fe, Sb and Zn. The contribution of indoor and outdoor sources was assessed by principal component analysis and showed the importance of the highways and the airport located less than 500 m from the Elderly Care Centre for both indoor and outdoor air quality.@en