Slip-resistant shear connections with preloaded bolts have traditionally been used in steel structures exposed to cyclic / fatigue loading or in cases when bolt slipping or connection deformations should be restricted. Hence, shear load is transferred through friction surfaces rather than through contact between the bolt surface and the hole. The main influencing parameters determining slip resistance of the connection are the friction between contact surfaces and the bolt preload level. This paper presents an experimental study of preloaded bolted connections under cyclic load, the main objective being to investigate the influence of cyclic load on the losses of preload force in high strength bolts and lock bolts.@en

In parallel with an experimental investigation of the flexural buckling behaviour of built-up stainless steel columns presented in the accompanying paper (Dobrić et al., submitted for publication), a detailed Finite Element Analysis (FEA) has been performed to simulate the experiment and identify the key factors affecting the buckling response. The FEA entailed realistic geometry, measured geometric imperfections and material properties of the specimens. Very good agreement was obtained between the experiment and FEA, which proved the capability of the computational approach to replicate experimental results and predict ultimate buckling loads. In the absence of explicit design rules for flexural buckling resistance of stainless steel closely spaced built-up members, the experimental results were compared with design predictions according to the existing European Standard and American Specification for carbon steel structures. The findings indicate that the mentioned design standards may be very conservative regarding the buckling resistance of stainless steel built-up members; this under-prediction may be associated with the impact assessment of chord slenderness and interconnection stiffness on the buckling response. The main purpose of this research is to establish a qualitative data base reliable for the further quantitative numerical parameter analysis and for the development of new design rules for compressed stainless steel cold-formed built-up members.

@en