Environmentally-benign materials play a pivotal role in advancing the scalability of energy storage devices. In particular, conjugated polymers constitute a potentially greener alternative to inorganic- and carbon-based materials. One challenge to wider implementation is the scarcity of n-doped conducting polymers to achieve full cells with high-rate performance. Herein, this work demonstrates the use of a self-doped n-doped conjugated polymer, namely poly(benzodifurandione) (PBDF), for fabricating aqueous supercapacitors. PBDF demonstrates a specific capacitance of 202 ± 3 F g−1, retaining 81% of the initial performance over 5000 cycles at 10 A g−1 in 2 m NaCl(aq). PBDF demonstrates rate performances of up to 100 and 50 A g−1 at 1 and 2 mg cm−2, respectively. Electrochemical impedance analysis reveals a surface-mediated charge storage mechanism. Improvements can be achieved by adding reduced graphene oxide (rGO), thereby obtaining a specific capacitance of 288 ± 8 F g−1 and high-rate operation (270 A g−1). The performance of PBDF is examined in symmetric and asymmetric membrane-less cells, demonstrating high-rate performance, while retaining 83% of the initial capacitance after 100 000 cycles at 10 A g−1. PBDF thus offers new prospects for energy storage applications, showcasing both desirable performance and stability without the need for additives or binders and relying on environmentally friendly solutions.@en

In alignment with widespread interest in carbon neutralization and sustainable practices, we disclose that conjugated polyelectrolyte (CPE) hydrogels are a type of recyclable, electrochemically stable, and environmentally friendly pseudocapacitive material for energy storage applications. By leveraging ionic-electronic coupling in a relatively fluid medium, one finds that hydrogels prepared using a fresh batch of an anionic CPE, namely, Pris-CPE-K, exhibit a specific capacitance of 32.6 ± 6.6 F g^-1 in 2 M NaCl and are capable of 80% (26.1 ± 6.5 F g^-1) capacitance retention after 100,000 galvanostatic charge-discharge (GCD) cycles at a current density (J) of 10 A g^-1. We note that equilibration under a constant potential prior to GCD analysis leads to the K⁺ counterions in the CPE exchanging with Na⁺ and, thus, the relevant active material Pris-CPE-Na. It is possible to remove the CPE material from the electrochemical cell via extraction with water and to carry out a simple purification through dialysis to produce a recycled material, namely Re-CPE-Na. The recycling workup has no significant detrimental impact on the electrochemical performance. Specifically, Re-CPE-Na hydrogels display an initial specific capacitance of 26.3 ± 1.2 F g^-1 (at 10 A g^-1) and retain 77% of the capacitance after a subsequent 100,000 GCD cycles. Characterization by NMR, FTIR, and Raman spectroscopies, together with XPS and GPC measurements, revealed no change in the structure of the backbone or side chains. However, rheological measurements gave evidence of a slight loss in G′ and G′′. Overall, that CPE hydrogels display recyclability argues in favor of considering them as a novel materials platform for energy storage applications within an economically viable circular recycling strategy.

@en

A subclass of organic semiconductors known as conjugated polyelectrolytes (CPEs) is characterized by a conjugated backbone with ionic pendant groups. The water solubility of CPEs typically hinders applications of thin films in aqueous media. Herein, it is reported that films of an anionic CPE, namely CPE-K, drop cast from water produces single-component solid-state pseudocapacitive electrodes that are insoluble in aqueous electrolyte. That X-ray diffraction experiments reveal a more structurally ordered film, relative to the as-obtained powder from chemical synthesis, and dynamic light scattering measurements show an increase in aggregate particle size with increasing [KCl] indicate that CPE-K films are insoluble because of tight interchain contacts and electrostatic screening by the electrolyte. CPE-K film electrodes can maintain 85% of their original capacitance (84 F g⁻¹) at 500 A g⁻¹ and exhibit excellent cycling stability, where a capacitance retention of 93% after 100 000 cycles at a current density of 35 A g⁻¹. These findings demonstrate that it is possible to use initially water soluble ionic-organic materials in aqueous electrolytes, by increasing the electrolyte concentration. This strategy can be applied to the application of conjugated polyelectrolytes in batteries, organic electrochemical transistors, and electrochemical sensors, where fast electron and ion transport are required.

@en