The aim of the present study is to evaluate the impact of heating rate on the microstructure and tensile properties of cold-rolled low and medium carbon steels. For this purpose, cold-rolled low and medium carbon steels were subjected to short peak-annealing experiments at 900 and 1100 °C under three heating rates (10, 450 and 1500 °C/s). The microstructure reveals a mixture of phases and microconstituents (ferrite, bainite, and as-quenched martensite) which are related to the carbon heterogeneities in austenite. The microstructural characterization suggests that the grain refinement achieved after ultrafast heating has a minor effect on the yield and ultimate tensile strength, compared to the relative microstructural distribution. It is suggested that the interplay of various strengthening mechanisms in samples subjected to ultrafast heating rates are responsible for the observed increase in strength and ductility.

The effect of heating rate on the formation and decomposition of austenite was investigated on cold-rolled low carbon steel. Experiments were performed at two heating rates, 150 ˚C/s and 1500 ˚C/s, respectively. The microstructures were characterized by means of scanning electron microscopy (SEM) and electron backscattered diffraction (EBSD). Experimental evidence of nucleation of austenite in α/θ, as well as in α/α boundaries is analyzed from the thermodynamic point of view. The increase in the heating rates from 150 ˚C/s to 1500 ˚C/s has an impact on the morphology of austenite in the intercritical range. The effect of heating rate on the austenite formation mechanism is analyzed combining thermodynamic calculations and experimental data. The results provide indirect evidence of a transition in the mechanism of austenite formation, from carbon diffusion control to interface control mode. The resulting microstructure after the application of ultrafast heating rates is complex and consists of a mixture of ferrite with different morphologies, undissolved cementite, martensite, and retained austenite.