More than 96% of steel in the world is produced via the method of continuous casting. The flow condition in the mould, where the initial solidification occurs, has a significant impact on the quality of steel products. It is important to have timely, and perhaps automated, control of the flow during casting. This work presents a new concept of using contactless inductive flow tomography (CIFT) as a sensor for a novel controller, which alters the strength of an electromagnetic brake (EMBr) of ruler type based on the reconstructed flow structure in the mould. The method was developed for the small-scale Liquid Metal Model for Continuous Casting (mini-LIMMCAST) facility available at the Helmholtz-Zentrum Dresden-Rossendorf. As an example of an undesired flow condition, clogging of the submerged entry nozzle (SEN) was modelled by partly closing one of the side ports of the SEN; in combination with an active EMBr, the jet penetrates deeper into the mould than when the EMBr is switched off. Corresponding flow patterns are detected by extracting the impingement position of the jets at the narrow faces of the mould from the CIFT reconstruction. The controller is designed to detect to undesired flow condition and switch off the EMBr. The temporal resolution of CIFT is 0.5 s.

In the present study, we have performed a series of numerical simulations of the turbulent liquid metal flow in a laboratory-scale setup of the continuous casting. The liquid metal flow was subjected to an external non-uniform magnetic field reproducing a realistic electromagnetic brake (EMBr) effect. The focus of this research was on the effects of the finite electrical conductivity of Hartmann walls on the flow and turbulence in the mold. To be able to simulate distributions of the electric potential and current in both the fluid and solid wall domains, we applied our recently developed and validated in-house conjugate MHD solver based on the open-source code OpenFOAM. The dynamic Large Eddy Simulation (LES) method was used to simulate the turbulent flow. The results obtained for the neutral (non-MHD) and MHD cases over a range of the imposed EMBr strengths – all for the perfectly electrically insulated walls – were compared with the available Ultrasound Doppler Velocimetry (UDV) measurements. A good agreement between simulations and experiments was obtained for all simulated cases. Next, we completed a series of simulations including a wide range of the finite electric conductivities (ranging from a weakly to perfectly conducting wall conditions) of the Hartmann walls for a fixed value of the imposed EMBr. The obtained results demonstrated a significant influence of the electric wall conductivities on the flow and turbulence reorganization. It is expected that here provided insights can be applicable for the new generation of the laboratory- and real-scale continuous casting setups.

In continuous casting, the flow structure of the liquid steel in the mould and the two-phase distribution in the submerged entry nozzle (SEN) are crucial for the quality of the produced steel. In order to effectively control the flow in the mould by electromagnetic brakes (EMBrs) and the injection of gas into the SEN, even a rough knowledge of the flow structure would be very helpful. In the framework of the TOMOCON project, the contactless inductive flow tomography (CIFT) and the mutual inductance tomography (MIT) will be integrated into a control loop for slab casters. This control loop will be developed and implemented at the Mini-LIMMCAST facility, which is available at the Helmholtz-Zentrum Dresden - Rossendorf. In this paper a short overview of this project will be given.