Stroke survivors often have difficulty performing activities of daily living (ADLs) due to hand impairments. Several assistive devices have been developed for stroke survivors to assist them with ADLs but most of these devices are difficult to don and doff for a stroke survivor due to highly flexed postures of the wrist and digits. This paper presents a hybrid 3D printed mechanical structure for an assistive hand exoskeleton created for stroke survivors. The design facilitates donning and doffing of the assistive exoskeleton by enabling an approach entirely from the dorsal side of the hand, thereby allowing the fingers to stay flexed. The design criteria, resulting design and the prototype development are presented. The initial prototype of the structure, using a hybrid combination of rigid and flexible materials, was lightweight (only 185 g), while maintaining a high range of motion. Future directions for further improvements and user studies are described.

@en

The large interest in robot hands and active hand prostheses has in recent years been joined by that in active hand orthoses. Despite the differences in intended uses, these three categories of artificial hand devices share key characteristics. Examination of the commonalities could stimulate future design. Thus, in this article, we undertook a comparative review of publications describing robot hands, active prostheses, and active orthoses, with a focus on mechanical structure, actuation principle, and transmission. Out of a total of 510 papers identified through the literature search, 72 publications were included in a focused examination. We identified trends in the design of artificial hands and gaps in the literature. After comparing their mechanical aspects, we propose recommendations for future development.

@en

Upper extremity function is affected by a variety of neurological conditions. Robotic exoskeletons offer a potential solution for motor restoration. However, their systematic adoption is limited by challenges relative to human intention detection and device control. This position article offers a focused perspective on this topic. That is, on how knowledge gained from the design and implementation of human-machine interfaces (HMIs) for bionic arms can benefit the field of rehabilitation exoskeletons. Three broadly used HMIs in bionic arms are here investigated, including surface electromyography, impedance, and body-powered control. We propose that combinations of these HMIs could push forward upper extremity exoskeleton development. In this context, we provide concrete applicative examples in two selected clinical scenarios, including post-stroke and Duchenne muscular dystrophy individuals. The discussed solutions can open new avenues for the translation of robotic exoskeletons in a large set of clinical settings and enable a class of exoskeleton technologies that could support a broader range of impairment and disease types.@en