This paper studies the dc fault development stages and analyzes the fault dynamics in a point-to-point multilevel modular converters (MMC)-based dc connection. First, the effect of the dc grid configuration on the normal operation was investigated by comparing an asymmetric monopole with metallic return and a symmetric monopole. Then, the main parameters that affect the dc fault response of a grid, such as the fault type, impedance and converter blocking, were examined. Compared to previous studies, which are based on simulation results, the analysis is performed hereby both in theory, deriving the equations that describe the dc fault stages, as well as using experimental results obtained in the designed laboratory setup. The setup consists of two MMC terminals connected to two ac sources representing independent ac grids. These terminals are connected using a simple dc link based on pi-section equivalent of dc cables. The obtained results, which verified the theoretical analysis, can be used to determine the protection function thresholds of the MMC, as well as to estimate the developed stresses on dc lines during fault conditions and to define the design requirements for dc breakers.

Due to the increase of power electronic-based loads, the maintenance of high power quality poses a challenge in modern power systems. To limit the total harmonic distortion in the line voltage and currents at the point of the common coupling (PCC), active power filters are commonly employed. This paper investigates the use of the multilevel modular converter (MMC) for harmonics mitigation due to its high bandwidth compared with conventional converters. A selective harmonics detection method and a harmonics controller are implemented, while the output current controller of the MMC is tuned to selectively inject the necessary harmonic currents. Unlike previous studies, focus is laid on the experimental verification of the active filtering capability of the MMC. For this reason an MMC-based double-star STATCOM is developed and tested for two representative case studies, i.e., for grid currents and PCC voltage harmonics. The results verify the capability of the MMC to mitigate harmonics up to the thirteenth order, while maintaining a low effective switching frequency and thus, low switching losses.

Grid faults are common in power systems and can have a severe impact on the operation of the converters in the system. In this paper, the operation of a Modular Multilevel Converter (MMC)-based Static Synchronous Compensators (STATCOM) is investigated during grid faults. The study focuses on the challenging internal control of the converter to allow the independent control of the energy levels of each arm, with the goal to maintain internal balancing of the MMC during contingencies. Extensive experimental results highlight the need for a sophisticated internal control. Moreover, the experimental analysis verifies that, by using the proposed control structure, the MMC can effectively ride through a fault on the AC side without tripping, while injecting the necessary positive and negative sequence reactive current levels according to the most recent grid codes.