The first generations of wave energy converters have had a number of forms, but all are essentially large steel structures concentrating the power take off onto small mechanical devices. A number of prototype devices have been installed offshore, but due to their high fabrication and installation costs, coupled with significant maintenance requirements, the production of electricity at an acceptable cost has remained elusive. To avoid the limitations of these devices, a second generation wave energy converter is being developed using electro active polymers (EAP), which are capable of generating electricity directly from wave action without the need for any mechanical power take off. The resulting system is flexible and possesses an infinite number of degrees of freedom, allowing wave energy to be captured more efficiently than with conventional devices. Deployed offshore, such a device would have no complex mechanical parts, would function silently, and would require minimal maintenance. The economics of such a system lead to predictions of a cost of electricity significantly below the levels of the first generation devices. The paper explains the principals involved in using EAP for the generation of electricity, the application of EAP to wave energy conversion, and reports key results from the ongoing development program. The paper also describes the main features of the prototype wave energy converter system presently under development for deployment offshore.@en

Over the past 4 years SBM has developed a revolutionary Wave Energy Converter (WEC): the S3. Floating under the ocean surface, the S3 amplifies pressure waves similarly to a Ruben's tube. Only made of elastomers, the system is entirely flexible, environmentally friendly and silent. Thanks to a multimodal resonant behavior, the S3 is capable of efficiently harvesting wave energy from a wide range of wave periods, naturally smoothing the irregularities of ocean wave amplitudes and periods. In the S3 system, Electro Active Polymer (EAP) generators are distributed along an elastomeric tube over several wave lengths, they convert wave induced deformations directly into electricity. The output is high voltage multiphase Direct Current with low ripple. Unlike other conventional WECs, the S3 requires no maintenance of moving parts. The conception and operating principle will eventually lead to a reduction of both CAPEX and OPEX. By integrating EAP generators into a small scale S3, SBM achieved a world first: direct conversion of wave energy in electricity with a moored flexible submerged EAP WEC in a wave tank test. Through an extensive testing program on large scale EAP generators, SBM identified challenges in scaling up to a utility grid device. French Government supports the consortium consisting of SBM, IFREMER and ECN in their efforts to deploy a full scale prototype at the SEMREV test center in France at the horizon 2014-2015. SBM will be seeking strategic as well as financial partners to unleash the true potentials of the S3 Standing Wave Tube Electro Active Polymer WEC.

@en