This study describes a novel integration of aerobic granular sludge (AGS) with a gravity-driven membrane (GDM) system at a pilot scale with a treatment capacity of approximately 150 L per day to treat raw domestic wastewater. The treatment performance and energy consumption of the AGS-GDM system were compared to the neighboring full-scale aerobic membrane bioreactor (AeMBR), treating the same wastewater at about 4000(±500) m³ per day. The AGS-GDM system demonstrated superior nutrient (nitrogen and phosphorus) removal as compared to the AeMBR. The GDM unit was continuously supplied with AGS-treated effluent. The GDM unit started with high [ >20 L per m² per h (LMH) ] flux, which gradually declined. The flux remained quite stable after 15 days reaching 3 LMH after 35 days without any physical or chemical cleaning. Our results suggest that AGS-GDM is a viable technology for decentralized wastewater treatment and reuse in water-scarce regions. The AGS-GDM could easily replace conventional AeMBR technology in the wastewater treatment and reclamation market.

The use of optical coherence tomography (OCT) to investigate biomass in membrane systems has increased with time. OCT is able to characterize the biomass in-situ and non-destructively. In this study, a novel approach to process three-dimensional (3D) OCT scans is proposed. The approach allows obtaining spatially-resolved detailed structural biomass information. The 3D biomass reconstruction enables analysis of the biomass only, obtained by subtracting the time zero scan to all images. A 3D time series analysis of biomass development in a spacer filled channel under representative conditions (cross flow velocity) for a spiral wound membrane element was performed. The flow cell was operated for five days with monitoring of ultrafiltration membrane performance: feed channel pressure drop and permeate flux. The biomass development in the flow cell was detected by OCT before a performance decline was observed. Feed channel pressure drop continuously increased with increasing biomass volume, while flux decline was mainly affected in the initial phase of biomass accumulation. The novel OCT imaging approach enabled the assessment of spatial biomass distribution in the flow cell, discriminating the total biomass volume between the membrane, feed spacer and glass window. Biomass accumulation was stronger on the feed spacer during the early stage of biofouling, impacting the feed channel pressure drop stronger than permeate flux.

Aquaporin plays a promising role in fabricating high performance biomimetic forward osmosis (FO) membranes. However, aquaporin as a protein also has a risk of denaturation caused by various chemicals, resulting in a possible decay of membrane performance. The present study tested a novel aquaporin based biomimetic membrane in simulated membrane cleaning processes. The effects of cleaning agents on water flux and salt rejection were evaluated. The membrane showed a good resistance to the chemical agents. The water flux after chemical cleaning showed significant increases, particularly after cleaning with NaOCl and Alconox. Changes in the membrane structure and increased hydrophilicity in the surrounding areas of the aquaporin may be accountable for the increase in water permeability. The membrane shows stable salt rejection up to 99% after all cleaning agents were tested. A 15-day experiment with secondary wastewater effluent as the feed solution and seawater as the draw solution showed a stable flux and high salt rejection. The average rejection of the dissolved organic carbon from wastewater after the 15-day test was 90%. The results demonstrated that the aquaporin based biomimetic FO membrane exhibits chemical resistance for most agents used in membrane cleaning procedures, maintaining a stable flux and high salt rejection.